RangeRovers.net Forum banner

ring

  1. 2013 RR L320 iPhone automatically answers before ring.

    Range Rover Sport / L320
    2013 Range Rover Sport. Can't stop iPhone 6s bluetooth from automatically answering before ring. Apple reset phone to original factory settings, no affect. Dealer insists all is OK with car settings. Any suggestions?
  2. Found my Gearbox Fault - reluctor ring is freely spinning

    Range Rover Mark II / P38
    Howdy, I gave up on figuring out my gearbox fault on my own and took my P38 in to the local Rover doctor. My problem is that I am not getting a speed signal from the transmission, I went through everything electrical that I could to no avail. The shop i took it too took the pan of the...
  3. Rebuilding EAS valve block what lube for o ring?

    Range Rover Mark II / P38
    Is there a specific o ring safe lube you would recommend for the EAS valve block rebuild? I have some Finish Line white Teflon lube for bicycles that I think would be safe. I know it needs to be non petroleum based to protect the o rings. What have you guys used? Any particular brand?
  4. L494 Taillamp Red LED Ring no longer illuminated

    Range Rover Sport II / L494
    The LED red ring has portions that are no longer working. Drivers (LEFT) side of the picture here. What's the fix? New taillamp assembly ? Under warranty so no biggie but I also didn't see a way to replace bulbs for this ring, is this correct ?
  5. Starter ring gear damaged

    Range Rover Mark II / P38
    Hi everyone, A new member on the forum here and a proud owner of a P38 1995 and RRC 1979. I have had the P38 for a few months now and haven't driven it too much. I noticed a grinding noise in the first weeks of having it while firing it up and after a while the grinding got too bad up until the...
  6. Piston ring size 5.0 S/C

    Range Rover Sport / L320
    Hi everyone ! I'm new member here. Sorry for my english in advance , since I'm from Russia) My car is 2010 RRS supercharged. I faced with a problem in my engine. Piston rings should be changed , but it is not simply as with 4.2 S/C. Because spare rings just don't exist for aj133. My friend...
  7. Reluctor or exciter ring - ABS fault at slow speed

    Range Rover Mark II / P38
    I'm trying to ask for your expertise before buying lots of parts and dismantling half of the car, so bear over with me... Problem is, my ABS/TC lights come on, when the car is moving slower than app. 2 Kph. Works flawless at all other times. Just changed ABS/TC ECU (fault: Sensor has short to...
  8. P38 V8 Reluctor Ring

    Range Rover Mark II / P38
    I may have found the problem with my P38 non-starting - it would appear there has been damage done to the reluctor ring that I hadn't previously spotted and it appears that I have two timing points on the flywheel - if it isn't the problem. it certainly won't help!See the pictures below...
  9. O Ring Screw Aggravation

    Range Rover Mark II / P38
    All I've been struggling for the past 2 hours trying to finesse the o ring screw out without stripping the head. I'm using a 16 inch #2 Phillips and attempting to extract the screw through the the vacated Hvac panel. The screw moves a very little bit but as soon as I start to try to turn it...
  10. SVR faster around the 'Ring than X6M

    Range Rover Sport II / L494
    Of course not controlled conditions but 6 seconds is a decent amount. http://www.autoblog.com/2015/07/17/bmw-x6-m-nurburgring-time/
  11. Ignition barrel bulb (green ring) qu.

    Range Rover Mark II / P38
    Evening all, can any kind soul advise me whether or not the little bulb that goes into the green ring to light it up on the ignition barrel is the same one that goes in the message center? Hope to pick one up tomorrow but unable to take it apart this evening to find out what it looks like...
  12. How to get the friggin fuel pump retaining ring off....

    Range Rover Mark II / P38
    Little help please. How do I get the retaining ring off the top of the fuel pump. The black six inch ring. Mine is metal. Tried unscrewing it like in one set of instructions, which I thought was madness just looking at it, then tried to pry it like other posts say. A Few pointers and tips would...
  13. Fuel Pump Metal Retaining Ring

    Range Rover Mark III / L322
    Can anyone describe how to get it off? I read a drift and hammer but still cant figure it out. Thanks
  14. Broken rivets holding reflector ring to flywheel

    Range Rover Mark II / P38
    Pulled my tranny to replace the drive plate and found one rivet sheared off of the reluctor ring. The other rivets are very slightly loose so the reluctor ring has a little movement. This damage was caused by broken pieces of the drive plate. A new flywheel is $758. Has anyone replaced the...
  15. Specification of Oil Filter Cap O ring - L322

    Range Rover Mark III / L322
    Hi Guys, Any one have the full spec of the O ring that goes round the Oil Filter Cap. x section and ID and OD My beast just dumped all its oil on the drive - Thats the second time in 6 months ! Changed the mounting bushes this time as well as seems the Oils buggered the rubber Also changed the...
  16. Abs ring broken, where to get one??

    Range Rover Mark II / P38
    Afternoon everybody, can anybody out there tell me if you can get reluctor rings as a stand alone item. My brakes have been acting weird for a bit (couple of mots ahem). Mot man has told me to stop taking the..... and fix it. After a lot of fun getting the abs sensor out I found the ring has...
  17. Quick O Ring question..

    Range Rover Mark II / P38
    Hi All, Ok..Being I had my AC recharged etc...Firestone put their 'dye' in it to see if it had leaks..told me bring it back in a couple weeks they'd check..for free...I took them up on that today..They checked it..said I have no leaks in the system..Would that mean I wouldn't have the O ring...
  18. Oil pressure switch O ring - what size?

    Range Rover Mark II / P38
    Hello all. I think i've found the source of my leak :); but it seems a pain to get to /:(. Does anyone know what size the oring is for the oil pressure switch; or even if it's metric or imperial. I thought it was the sump for a while, and even the rear main seal (which havn't been ruled...
  19. O Ring Heater Core Replacement Full Video of Procedure

    Range Rover Mark II / P38
    Hi, After following the advice on this forum I managed to change the o rings on the heater core, what a job it turned out to be, only really because of the clamp on the pipes, getting it aligned. Anyway, after years of using youtube and the internet to learn how to do or fix something I...
  20. Where to buy a Oil relief valve "O'' ring. Help

    Range Rover Mark II / P38
    Hello guys. I have a 97 RR SE with a 4.0L engine. I have noticed that its leaking alot of oil and i jacked it up i noticed it was coming from the oil relief valve. I have seen on a couple threads on here that its the "O" ring and i cant seem to find the "O" ring. I live in Pomona, California...
Top