RangeRovers.net Forum banner

replaced

  1. Has anyone replaced the shifter paddles?

    Range Rover Sport II / L494
    I'm thinking about replacing the stock shifter paddles in my ordered V8 SC with the OEM red anodized shifter paddles. Has anyone on here done that and have any idea how long it takes to do that replacement?
  2. 2015 RR HSE Differential replaced

    Range Rover Mark IV / L405
    I just recently had the front differential replaced on my 2015 HSE with 42000 miles. I started hearing a noise from the front of the RR that sounded harmonic (rhythmic?) and increased and decreased with acceleration - de-acceleration. I took it into my local RR dealer and they said that the...
  3. Replaced front differential on 2015 HSE

    Range Rover Mark IV / L405
    I started hearing a harmonic noise coming from what sound like the drivers side front end of my 2015 HSE with 42,000 miles on it. I thought it was a CV joint or possibly a wheel bearing but when I took it to our local RR dealer they said it needed the front differential replaced. I picked up...
  4. P0128 - Thermostat replaced - still intermittently failing

    Range Rover Mark III / L322
    Hi Everyone, I had a shop replace the thermostat in my 2006 Range Rover Supercharged. 144k miles on the vehicle. Fault codes prior to dropping it off were P0171, P0174 and P0128. Shop replaced the thermostat ($560 total) and stated when they performed a test drive P0128 came back. They...
  5. Cruise Control Still Faulting After Spiral Cassette Replaced

    Range Rover Sport / L320
    Replacing the spiral cassette coupler in the steering column fixed a litany of issues in my steering wheel controls, but from time to time I'm still getting the Cruise Control Not Permitted Issue popping up albeit far less often and more self-correcting than before when it was always there...
  6. Pad sensors need replacement when pads replaced?

    Range Rover Sport II / L494
    Hey all! Finally have some time to get my Disc Italia ceramic pads installed but had a Local shop tell me Id need to have replacement sensors as well for all my calipers. Seems excessive ? Find a new shop?
  7. Replaced O2 sensors, having slow response

    Range Rover Sport / L320
    Hi, I had a shop replace the O2 sensors in the car, all 4 brought from trusty online rover parts we site. Now i am getting P0133/153 And P0171/174 Bank 1 or 2 lean and, Bank 1 or 2 slow response. One or the other after clearing codes. They shop replaced the front bungs on both banks. I...
  8. P2097 - I have replaced almost everything ... RoverGuy7 help

    Range Rover Mark III / L322
    2007 L322 SC 108,XXX (bought it at 59k). I started getting P0297 - Post Cat Trim Too Rich Bank 1 about 2 months ago and I cannot get rid of it. I am hoping RoverGuy7 (Dave) can give some input - you have helped me numerous times as I lurk your posts. I have replaced the following: Air filter...
  9. Replaced starter and still will not start 09 supercharged

    Range Rover Sport / L320
    I had a coolant flush and oil change two days ago. Woke up today and had no crank. Tested battery and it has proper voltage. Tapped on starter and it did crank. Bought a remanufactured starter at autozone and had trouble getting it installed but finally got it and put everything back together...
  10. 2010 HSE EAS Compressor Replaced

    Range Rover Mark III / L322
    Hello, I have a 2010 Range Rover HSE that had a persistent Suspension Fault error show up. I've had this code for almost a year now without any issues with ride height. I've decided to try and fix the code as I want to sell it in the near future. The compressor is a Hitachi style and I...
  11. Replaced A/C controls. No A/C

    Range Rover Mark III / L322
    So, The climate control panel on my L322 was looking pretty rough so I bought a replacement off eBay. I hooked it up and all the lights functioned normally. There was however an extra hookup in the back for what I think are heated seat. My original climate control didn’t have the seat buttons...
  12. Has anyone ever actually replaced the cubby box struts?

    Range Rover Mark III / L322
    I've read countless threads and am surprised at the lack of information on replacing the cubby box struts, since they are such a common failure. I pulled the console apart the other night as far as I was willing to go. I see where I can drill out the rivets on the lid portion of the cubby box...
  13. Replaced spark plugs and crankcase PCV vent valve

    Range Rover Sport / L320
    Hello all, I just wanted to report back on my installation of new plugs and PCV valve this morning. On a level of difficulty, i'd say it's a 4 out of 10. I say that because you will need a good set of extensions and the ability to work in tight spaces for the driver side rear most spark plug...
  14. Replaced water pump, now all fluid leaks out immediately

    Range Rover Sport / L320
    I have a 2010 RRS SC that I have just bought. I replaced the water pump because the dealer said it had a small leak. I used genuine LR parts, replaced the water pump, plastic tube deal, and o ring. When i add coolant, it immediately starts dripping out from what I think its the plastic tube. I...
  15. Replaced Tailgate Release Button with Wireless 12v Relay

    Range Rover Mark II / P38
    A very cheap option $10 fleebay....small enough you can tuck it in there and it will never see the elements....once setup, even if you loose power it retains the simple latching config you plug in there.... and I just left the old button in place......just an option I thought I would share.
  16. Rear drop link replaced. Supension fault now!

    Range Rover Sport / L320
    Hi I replaced the drop link. Now i am getting a warning that i have a suspension fault and it will go down unless i reduce my speed. Do you have to perform a reset or something.
  17. replaced worn rubber steering wheel spokes with oem chrome

    Range Rover Mark III / L322
    was in my friends 2012 rr sc and noticed the steering wheel spoke covers were a nice satin chrome finish, and my 08 rr sc has the worn rubber coated ones. dealer has a kit that allows u to change them to the satin chrome finish change mine yesterday and it was an easy fix and really looks fresh...
  18. Truck won't start after CPS replaced

    Range Rover Mark II / P38
    Hi Guys, I started a thread last week about my truck ('01 4.6 HSE, Bosch, 155k miles) dying suddenly at idle, but for some reason when I go to the thread now it just shows as a totally blank page...so starting a new thread...with a new issue anyway. So determined that the issue was the CPS and...
  19. Replaced suspension components now lots of errors

    Range Rover Mark III / L322
    Ok, so over the past several months I have had my '07 SC 4.2 up on jacks and replaced all of the suspension bushings, control arms, wheel bearings, air bags & struts, inner/outer tie rods, and both passenger front/rear axles. All has finally been replaced and when I started it up for the first...
  20. P0303 Solved, Fuel Injector Replaced, but....

    Range Rover Mark II / P38
    My 1997 P38 4.6L was throwing the "usual" collection of codes which I pulled up with my Nanocom: P0303, P0300, P1313. I first replaced the spark plugs, ignition wires (8mm) and the coil for cylinders 2 & 3, and kept getting the same codes after resetting the MIL. I finally diagnosed it to a...
Top