Search Results for ‘reader’

Hi All, First let me apologize for the long title and what might be a longish post. So i'm looking for an error code reader/diagnostic tool for my 2011 L322 5.0 petrol. Main things i want it for, are just encase i get some type of electrical/fault code that puts it into 'limp' mode, or some...

Hello All.. Im looking for a inexpensive diagnostic tool to read and reset codes on my 2004 Ranger Rover. I see a few on ebay and amazon but not sure which ones will work with the Rover. Any help would be appreciated. Thanks.

Hey Everyone, I'm Brad, a Brit living in Florida. Currently developing a bluetooth panel for our cars. B

I see Gap Diagnostics has a blue tooth OBDII scanner (IIDTool BTII) tool for $500, has anyone found or used a lower cost unit that can reset Oil and service intervals?

I have a Vogue SE 3.9 auto and have been reading about the ecu and would like to get myself a code reader. Someone on eBay is selling a cable with a usb plug at one end and a special LR plug at the other which I beleieve needs to be used with a laptop and some freeware but I was thinking I...

Hi All, I have a weird issue, when i drive about 50 to 60 mph, the transmission keeps shifting between 5 and 6 and back to 5 like it struggling to find the right gear. It does this continuously shifting up and down every 0.5 seconds. I have flushed the transmission fluid and put in a new pan and...

I am looking at the options for a fault code reader. Did find some software but even with the recommended connector could not read the Control modules. My understanding is that all cars should be readable , but don't want to be purchasing on pot luck. I am aware of the Gap too; but as I am...

Hello chaps, I was just digging around in a box of stuff that I have been given and have come across a brand new Launch Creader VI. Upon investigation I have found out that it had been purchased on EBay and is a fake of the real one, apparently loads of them out there upon talking to the "real...

There are soooo many code readers out there...I am looking for an inexpensive unit that will read the L322 codes and then be able to reset engine light or even the oil change, yet that may need a more sophisticated tool...any recomendations on a unit?

Hi all, I got this weird issue, occasionally my temp gauge on the dash seams to get stuck at 0 (stone cold) , but if it plug in an odb reader it shows the coolant temp correct at about 92 deg c. It also gets a P0116 error code when it happens. If i turn of the engine are restart it seams to go...

I have a 2000 P38 4.6. After build vehicle was running a bit rough.... did a few bits and pieces to fine tune my rebuild and locate errors I made along the way but still have the Service Engine Soon light flashing. I bought an ACTRON CP9185 to diagnose any faults it may have and the unit only...

Hi All My name's Karl, I live in the UK and I'm owned by a 2001 2.5 TD County. It's owned me for about 2 1/2 years and I've done a lot of work on it with the help of this forum. I've just had a problem with the brakes, that I could find very little imformation on the forums and so now I think I...

I recently bought a 93 Range rover, the wife and I think this is the perfect project car, however after driving it for 3 days, the check engine light came on and after doing some reading on this forum, I looked at the onboard diagnostic reader under the passenger seat. Completely blank. I set...

Hello Fellow Range Rover Owners, New to the group but long time reader...thought I was a member all these years, but I guess not.....a most helpful forum by the way. Thank you, Dave White

I just recently acquired the software and hardware kit from RSW Solutions. I am amazed how efficient and well this system works. I am having some issues with the check engine light coming on again, but when I plugged in the cable, I got the following message while I will attach in a picture. It...

About an hour after I changed my oil my SES light came on. Probably not related to the oil change but I thought I'd share anyways. When I plug my OBD2 Reader in I get the message "LINK ERROR". Is there a certain way to connect the reader? I've tried reading the code with the key in aux position...

Can someone tell me if the Denso DVD unit from a L320 2007 would be a direct replacement for my 2005 Denso DVD unit ( both look the same ) ? Different head units but still both touch screen units. Thanks

Hi everyone! I am a new member and I will eventually get around to introducing myself in the new members section. I'm originally from Southern California but I attend college in Idaho and now I'm temporarily living in the Denver, CO area until school starts up again. I am a new owner of a 2004...