RangeRovers.net Forum banner

procedure

  1. Service Procedure for Replacing Brake Booster

    Range Rover Sport II / L494
    Does anyone have the service procedure for replacing the brake booster? I'm interested in knowing if the procedure calls for removing the windshield wipers and the upper windshield wiper cowling. Had the booster replaced under warranty but they broke a bracket that holds the plastic cover over...
  2. L494 Brake Bleed Procedure

    Range Rover Sport II / L494
    Hi All, After a pad failed/disintegrated on me and a road side recovery agent incorrectly bleeding the brakes back up, I have a very soft long brake pedal. Land Rover don't seem interested in fixing it. Does anyone have the full bleed procedure for a L494 Sport please?
  3. Brake Line Replacement Procedure Help

    Range Rover Mark II / P38
    Hi all I have a burst brake line on my Rear RH side where the line connects. I am wondering what the correct procedure for replacing this would be? I have the correct replacement brake line, connectors, tools and fluid. Do I need to bleed the brakes first considering that there’s already a...
  4. Procedure to diagnose no crank

    Range Rover Mark III / L322
    Is there such a thing? I can’t find it in rave.
  5. '93 4.2L ignition timing setting and procedure

    Range Rover Classic
    I looked guys, everywhere, and cannot find a description of the procedure for adjusting the timing on my 4.2L. Any description at all merely says“Use a timing light and aim it at the harmonic balancer”.DUH, I get that, I can do that all day, but WHAT lines do I line up with thefixed (plate...
  6. Anyone have a detailed procedure on EAS Manual Operation?

    Range Rover Mark III / L322
    Maybe with pics? I'm in a Can Bus fault and need to inflate my front bags. They are not quite the bump stops but close.
  7. Reset oil change indicator on a 2010 - tool or procedure?

    Range Rover Sport / L320
    Can anyone point me at a tool or (even better) procedure to reset the "Service Required" oil change indicator on a 2010 Range Rover Supercharged (Autobiography)? I found steps for everything up to 2009, but not 2010! Thanks Dave
  8. '93 LWB rear brake bleeding procedure

    Range Rover Classic
    I'm writing this while ducking my head for the flaming I'll get for not referring to the factory manual, but can ANYONE briefly describe how bleeding the rear brakes in my '93 with ABS differs from a "normal" vehicle with a vacuum booster and master cylinder? I've searched this site ad nauseum...
  9. Rear Rotor Procedure 2010+ (Is it different?)

    Range Rover Sport / L320
    I've got a 2010 RRS HSE, and was planning on doing pads and rotors all around this weekend. I noticed that there's a bunch of information on special steps necessary when doing discs on the rears for 2006-2009 models. I was wondering if the same apply to a 2010+? I ask because a some of the...
  10. No Start Test Procedure - 12V at Coil ?

    Range Rover Classic
    Proceeding through the factory no-start ignition test procedures I'm stumped at Test 3: Between the HT coil negative and Battery positive I read 12V, bit with ignition on and off. Above Test procedure states I should rad 0V. The test procedure does not allow for this result, so what is my...
  11. ABS condensed bleed procedure?

    Range Rover Classic
    Can anyone confirm this procedure is correct for 1995 LWB? http://c7743.r43.cf2.rackcdn.com/Downloads/instructions/abs_brake_bleed_rrc.pdf
  12. 2012 -how to install trailer hitch; procedure?

    Range Rover Mark III / L322
    bought hitch-full tow bar, not just the receiver, no instructions...thanks. Or picture of underside mounting...
  13. Is there a manual procedure for closing the sunroof?

    Range Rover Sport / L320
    Is there a procedure to close a RRSport sunroof in the case of electrical system failure? Nothing in the owners manual that I can find. Most cars I've owned in the past had a way to crank it closed in an emergency.
  14. drivetrain-wheels etc manual dignostic procedure?

    Range Rover Mark III / L322
    Hi on monday my mechanics will be changing brake disk as well as some suspension parts(mentioned in my previous post) Just to avoid potential problems I would like to ask You about some procedures So during that repair I would like to check also descibed i previous post harnshness.. to do so I...
  15. L322 Car Lift procedure

    Range Rover Mark III / L322
    I plan on getting my new exhaust installed later this week, Would anybody happen to know what i should tell the exhaust shop for lifting the car on the hoist so i dont damage the air suspension?.
  16. Battery replacement procedure

    Range Rover Mark III / L322
    Hi everyone, I have a range rover supercharged 2010 and im trying to install a new battery. The battery wont fit between the wiper cowl and the ECU with a fan. Do i need to remove the wiper cowl or the ECU? Any reset procedure once complete? Thanks, Gary
  17. O Ring Heater Core Replacement Full Video of Procedure

    Range Rover Mark II / P38
    Hi, After following the advice on this forum I managed to change the o rings on the heater core, what a job it turned out to be, only really because of the clamp on the pipes, getting it aligned. Anyway, after years of using youtube and the internet to learn how to do or fix something I...
  18. Blend Motor repair procedure

    Range Rover Mark II / P38
    I think I remember someone posting a repair for the "circuit" board for the motor. My motor and gearing is all intact and working. I think the pointometer on the board may be broken. Does anyone remember the link. I did some searching but i'm coming up short. Thanks
  19. All doors locked, EKA procedure not working, how do I get in?

    Range Rover Mark II / P38
    All doors locked, EKA procedure not working, how do I get in? And before anyone else says it, yes, I am an idiot for getting into this situation. Situation: Trying to fix issues in using EKA procedure for unlocking doors. Usual EKA procedure no longer works and I suspect micro switches in...
  20. Front Sway Bar Removal Procedure

    Range Rover Mark III / L322
    I am trying to replace my Front Sway bar as the bushings are shot, I removed the Links and popped it off the Front Sub frame but ALLDATA is saying remove bolts and drop the rear of the sub frame? Not real thrilled at the thought of doing that I have found ALLDATA to miss steps in repair...
Top