Search Results for ‘press’

Hello, I have just acquired a CVC pre production P38 which is in need of some TLC and will no doubt be pestering the forums for guidance on the various dramas as they unfold. I have undertaken an "A" suffix restoration but think the P38 might be slightly more complicated! Best wishes, David

I have a problem with my Navicomputer. The screen is blue with orange text that say: Loading of software required. Please insert A suitible CD-ROM When i insert a navi CD, the screen says press ok using the rotary knob. When i try to press ok, nothing happens. Anyone had this problem before?

I'll get started:

Hi All, Fresh into the joys of P38s and immediately need some help and guidance. After about a month of enjoying the drive, my P38 (1999, 4.6 V8 Vogue GEMS) seems to have been upset about something. Coming back to it after finishing work, it just wouldn't accept the remote key (only one key!)...

My P38's key fob stopped working a few weeks ago, and it was the only one that came with the car. So it isn't on the road at the minute, I managed to get it started with the EKA code yesterday and tried again today, but when I turned the key to start it, it said 'Engine Disabled, Press Remote'...

Hey Guys, I'm having an issue with my NAS 99 bosch p38, and before I jump to conclusions (and assume it's the BECM) I just wanted to run my problem by the board first (and yes, I've searched and search), especially before I begin tearing out the BECM in below freezing temps. I went away...

i get this message on start-up from time to time; haven't picked up a pattern yet. sometimes preceded by something about low pressure tire monitor setting. i have my LTPM set for light load and my tire pressures read in range (33f, 37 r) using the tire pressure readout (same reading with a...

Hello all, I know this has been covered before, so I apologize about that. But I'm wondering why this is a recurring problem with my 02. Just about every time or every other time I get this message. Why does it keep requiring me to do so? Everything is original, (becm, keys, etc). Becm has...

Hi, I have had lots of trouble with locking and unlocking of door locks from, I am told, "Stray Signals" from my garage door and house alarm, so I replaced the receiver with one of a different frequency and it seemed to do the trick. The problem is back but it cannot be associated with the...

Just took delivery of 2014.5. Every time I start the car this pops up on the dash - i either press OK button on steering wheel or if I do nothing a second message comes up then it goes away after a while - Any ideas on what this is?

Just been reading through several pages of posts and isn't it a sad fact that only faults get reported. Someone coming on here to find information on buying a Land Rover would think that all they do is go wrong Well mine is 12 years old, done 116,000 miles, and went for it's usual trip to the...

taligate latch - P38, center power unit - won't unlock lower tailgate on second press Good Morning all - Happy New year!! First press of the button - top hatch opens normally Second press of the button - I can see and hear the motor firing and pulling the mechanical mechanism - but the lower...

Hi all So this is the situation im currently in; My 97 P38 decided the other day that it didnt want to work anymore and that it would disable itself, My remote does not work as the contacts for the battery has disappeared so ive been using the key in the door lock quite happily for the last 3...

Hi All, I realised yesterday that i had not pressed this button for months now. But, a sporty audi needed to be shown my rear lights at a traffic lights grand prix. Well experience also helped. So when was the last time you pressed, just for the heck-of-it?:twisted: Merry Xmas to you all Tony