RangeRovers.net Forum banner

pipes

  1. 2.5dse injector pipes

    Range Rover Mark II / P38
    Guys one of my high pressure pipes from my injector pump to the injector has split and I need a new one, I was thinking of geting a set of six. Where can I get them from Thanks K Sent from my GT-N8010 using Tapatalk
  2. ‘97 DSE - Oil & Auto coolers: renewing pipes.

    Range Rover Mark II / P38
    Hello all, Ready to fit I have a brand new auto gearbox oil cooler with pipes plus new engine oil cooler pipes to fit to existing engine oil cooler. I’m expecting a messy job but, can anyone provide any tips or hints when fitting and can it be done with normal non-specialty tools? I’m hoping...
  3. Oil cooler and pipes leaking

    Range Rover Mark II / P38
    Diesel engine. The hoses at the oil cooler started leaking, so I have just fitted a new oil cooler and pipes. All well for the first couple of days. This morning the pipe to the rear going into the engine is dripping oil. These two pipes seem to be just a push fit held with a single metal...
  4. breather pipes

    Range Rover Mark III / L322
    I have 2 rubber pipes on the top of the engine one is leaking oil onto one side of the engine (UK driver side) the other pipe goes across the engine and disappears down the back (near side) one has a split in it, the other prob shot as well, is there a part number for them? can I get them...
  5. Front brake pipes

    Range Rover Classic
    I've just put some longer hoses on my RR classic 1990 NON abs it has 3 bleed nipples on callipers. And now I can't remember if I put the correct hose on correct pipe will it make any difference if It does.has anyone got a picture or diagram of which goes where. I have replaced the calliper...
  6. Struggling to Find Spare Parts - Coolant Pipes

    Range Rover Classic
    Hi, I'm struggling to find replacements for these two pipes. Rimmer Bros aren't being the most helpful... It's for a 3.9v Petrol Classic - the two coolanttubes underneath the inlet manifold, Thanks in advance,
  7. Fuel tank cap with both supply and return pipes needed

    Range Rover Mark II / P38
    The supply pipe from the fuel tank has cracked and now the vehicle has a lot of airlock and therefore not starting due to the supply pipe sucking in air bubbles. I have tried to seal the pipe but it keeps cracking and causing the same problem. I am now looking for the fuel tank connected with...
  8. Brake pipes

    Range Rover Mark II / P38
    Evening, well tomorrow I start to replace the brake pipes as one near the Drivers side rear (uk) has split. So looking at it wondered if there any words of wisdom! 2000 4.6.. Tia
  9. Replacng brake pipes

    Range Rover Mark II / P38
    I strongly suggest that any brake pipe replacement be done using cupro-nickel piping and not oem range rover steel junk. as a long time volvo restorer i can attest with 100% certainty that volvo brake pipes going back well over 30 years never rust or corrode. you can pull brake pipes off a 1980...
  10. Brake Pipes

    Range Rover Mark II / P38
    All Yesterday went outside to find a puddle of brake fluid under rear passenger wheel area. Appears the the brake pipe in the vicinity of the air bag either corroded or burst. I haven't removed the wheel and got it up in the air yet to identify the specifics of the issue. With that, how...
  11. PCV Pipes - ok to just replace pipes

    Range Rover Mark III / L322
    Hi All, Just little advise, as you may be aware I posted about oil leak. I have looked and found both PCV pipes top engine had failed very badly !! see photos. Which garage believe is the leaking oil and causing pressure to head gasket seals.. So replace these first see if the leak stops...
  12. Thor vacuum pipes

    Range Rover Mark II / P38
    Hi, I've just noticed after rebuild of my 4.6 Thor engine that I'm a vacuum not short ! It's the small one on the rh end of injection, anyone got any idea where this comes from , thanks in advance
  13. Water pipes changing help / advice

    Range Rover Mark II / P38
    Just a quick one please Can anyone advise me if its possible to change both the top water pipes just gaining access by removing the fan cowl ? ie FAN ON and RAD in but just unclip the cowl ? is it easy or difficult ? Cheers
  14. PCV Questions. Where do these pipes go.

    Range Rover Mark III / L322
    Hi all. My brother just got a 2004 l322, and it has lean codes leading me to believe it has a vacuum leak. I was taking a look at it today; and first thing i checked was his pcv system. Previous owner said he had just replaced it; and it looks pretty new, as do the hoses; but....... it seems...
  15. brakes pipes

    Range Rover Mark II / P38
    my p38 range rover had to have new brake pipes for a new mot, the other week, the garage did the work, they said the pipes ran along the chassie so do they need to take the wheels off in order to do the work??? anyone help asap. Because since having the work done there is now 3 wheel nuts...
  16. Water pump pipes

    Range Rover Mark III / L322
    Hey guys, I just did a water pump change on an 05 HSE and the tubes that run to the manifold popped out from the rear of the engine. I think I tore one of the rear o-rings when I reinserted them. Bloody great leak when I refilled the coolant. Has anyone removed just the rear manifold without...
  17. Fitting new cats/front pipes and X-members

    Range Rover Mark II / P38
    A very quick question. We now have rattly cat syndrome, the front pipes are getting a bit tired and having completely given up on finding anyone here to make me anything halfway acceptable, I'm going to bite the bullet and order new stainless sport cats from Rimmers. Looking at the picture...
  18. Range Rover Vogue 2007 brake pipes and top hub joints

    Range Rover Mark III / L322
    Hi im new to this forum. I have just had my car serviced and have been told that the brake pipes need replacing due to age and should be done every 6 years. Is this true? Also im being told there is play in top hub joints. What does this mean and how important is it that this done? Is it an...
  19. Power Steering Pipes - Compatability ?

    Range Rover Mark II / P38
    Hi all Can anybody confirm if i can replace my power steering pipes on my 1995 p38 4.6 with replacements from a 1997 p38 4.6 thanks
  20. Just replaced O rings on the heater pipes but..

    Range Rover Mark II / P38
    It didn't look like they had been leaking, however the screw wasn't tight at all, the O rings were flattened and broken and the top pipe had 2 rings on it? I was expecting to actually see visible signs of coolant dripping. The range is only used at weekends so I guess they could have dried up...
Top