RangeRovers.net Forum banner

pipe

  1. Range Rover Classic
    I am looking for some pointers on removing a 17mm bolt that sits right below a brake pipe on my 91. I am trying to remove the bracket so I can keep the pipes and hoses attached when I lift the caliper off. I cant get anything in the tight space and with the coil spring being right there. Any...
  2. Range Rover Evoque / L538
    “Allow myself to introduce myself” ~ Austin Powers My name is Ozzie and I own a 2014 Range Rover Evoque which I purchased new while it was still on a ship coming from Liverpool in the UK to the States. I’m writing this post because I’m interested in knowing: 1) Have any Evoque owners...
  3. Range Rover Mark II / P38
    Gents, The intake pipe of the V8 GEMS has two "boxes" on it, I assume these are there to equalize pulses in the intake, please correct me if I'm wrong.. If I take these boxes of, does it increase throttle response? I thought I better ask before I do something I might regret later on ;)...
  4. Range Rover Mark II / P38
    Hey guys, My P38 2.5 diesel engine coolant pipe leaked(STC2198) and now been welded. I wish to have in replace but where can I buy the replacement? I been asking around from rimmerbros, lrdirect, island4x4 and searched from internet, answer was Sorry that part number is now obsolete from...
  5. Range Rover Classic
    Need location of all brakepipe connections. Anyone with the ANR1118 Wabco ABS modulator ( with ETC) and right hand drive. 1992 to 1995. The RAVE workshop manual doesn’t show clearly. Cheers in advance.
  6. Range Rover Sport II / L494
    Hey all, I've got a 2015 RRS V6, and apparently the Intake Outlet Pipe has failed causing coolant to start leaking out of the engine. Since it's a plastic part, it's not covered by my CPO warranty and I'm wondering if I could save myself $1800 by doing the replacement myself. Apparently the...
  7. Range Rover Mark II / P38
    Hi all, I’m looking to identify a pipe within the engine bay. Per the title it’s a ‘97 LHD diesel. To describe it, the pipe is black and exits the bulkhead right behind the the rocker cover. It then goes down and disappears behind what would be the cylinder head but I cannot see where to. I...
  8. Range Rover Mark III / L322
    Another technical question: The crankcase gases are routed back into the intake system. I disconnected this pipe from the air filter housing because I thought this way the engine doesn't get hot gases and doesn't overheat so fast. Does this pose a problem to the PCV valve ( is there a vacuum...
  9. Range Rover Mark III / L322
    Hi guys I noticed a small filter on the right size of the engine that seemed to have nothing connected at the bottom? I looked around and found an open ended pipe near by tucked to the side, should this connect into the bottom of the filter? what is the filter for? Thanks
  10. Range Rover Mark III / L322
    Hi, Range Rover Vogue 3.6 v8 twin turbo, strange things happening, lots of smoke from Lh side exhaust, intermittent limp mode activation (when switched off it clears for a while, I looked under the bonnet to see if there was anything obvious and found this rubber hose detached, but for the life...
  11. Range Rover Mark II / P38
    Hi guys I need help I have a leak from the brake pipe atvrhe rear RHS It looks a pig to get to as its high up near the chassis Any advice Thanks Sent from my GT-N8010 using Tapatalk
  12. Range Rover Mark II / P38
    I am busy unbodging my coil car to go back on bags and I have a question regarding the plumbing... The cretin that removed the system seems to have chewed the pipes off at the valve block as there is no colour coding or any form of marking, not to mention the ends of the pipes are badly...
  13. Range Rover Mark III / L322
    Hello all, I have a 2010 Rover full size with a 5.0 V8 Jag engine. I'm replacing the water pump and there is a small plastic pipe that exits the outer part of the pump and contains a vacuum line into the throttle body area. Here is a pic, its identified as a "bleed pipe connection." I...
  14. Range Rover Mark II / P38
    Hi all. Year 2000 P38 4.6 Vogue on LPG Under the bonnet today messing about with bits and bobs and heard a hissing sound. It's coming from the pipe labelled 6 on the eas which I believe is the pipe to the reservoir. F on the picture. (this isn't a picture of my EAS. Its a generic picture...
  15. Range Rover Mark III / L322
    Vehicle: 2004 RR HSE BMW M62TU 4.4L gas engine I noticed that the the hard plastic pipe that connects to my purge valve is damaged at the quick connect mechanism and need to replace it. I figured that I'd also replace the purge valve while I'm at it. Does anyone have the part numbers for these...
  16. Range Rover Mark III / L322
    For a while I have heard an unusual sound emanating from front passenger side front wheel well. Tonite I confirmed the seal between exh pipe and manifold is puffing air. Got an engine light the other day so probably is why. My question is to anyone who has done this repair. Will the parts...
  17. Range Rover Mark III / L322
    Hi, First time posting here. Been working on my own Disco II's for a few years including head gasket replacement so I have some LR experiences. 04 HSE 99K miles, everything works and (seems) normal and engine running fine. Been away for two months and parked in the garage with battery...
  18. Range Rover Classic
    Dear Members, I have a Range Rover Classic MY1989, and since two days I noticed that the steering fluid's level is low.I checked the pipes connected to the power steering fluid reservoir, and I found that one of two pipes needs to be replaced (not the one that stays on a high level but the...
  19. Range Rover Classic
    Been helping reassemble a RHD '95 soft dash that has been completely stripped for restoration and have run into a problem. The ABS modulator had been taken off along with some of the brake pipes. Now we are trying to work out which pipe goes into which port. RAVE says that all ports are...
  20. Range Rover Classic
    My RRC is now in need of a new Y-pipe (with cats). I know I can go to the usual places, but I found this on fleabay. Has anyone had any experience with Performance Peddler or the Davico y-pipe on their RRC? TIA.
Top