RangeRovers.net Forum banner

pinout

  1. Fusebox pinout

    Range Rover Mark II / P38
    Pin C175 C173 C172 C174 1 2 RH Headlamp wiper LGU - R BLOWER C240 4 WLG - 2 Condenser Fan C197 BR - GND RL1,2+11 (4,3) B output RL10 - 3 Condenser Fan C197 B Calef. Parabrisas...
  2. Dash switch pinouts

    Range Rover Mark II / P38
    Does anyone have the pinouts for the dash switches? like the hazard switch.. want to wire my pump to the now unused eas lock switch ..
  3. Cruise Control ECU (AMR2009) pinout?

    Range Rover Classic
    hey all. I'm trying to find the pinout for AMR2009 ('93 RRC LWB) so that I can retrofit a cruise control ECU from an '04 D2. Is the pinout for AMR2009 the same as for a D1 (AMR1173) ? I looked in RAVE, the wiring diagrams are not as good for the Classics as for the D2 and came up short. D1...
  4. Need Pinout for this 2009 Range Subwoofer Amp Harness

    Range Rover Mark III / L322
    Can someone help me with the Pinout of this Harness from my 2009 L322 subwoofer Amp. I am adding a sub to my system and I want to tap into it for my LOC. I know the RED wire is a constant 12V. BIG THANKS in advance.
  5. P38 ecu pinout to crankshaft sensor

    Range Rover Mark II / P38
    Hello, please could somebody help me with ecu pinout to the crankshaft position sensor i mean an image because some one have replace the CPS connector and the wires colors are dfifferent to the one on ecu thanks
  6. P38 ecu pinout to crankshaft sensor

    Range Rover Mark II / P38
    Hello, could somebody help with the wiring diagram of crankshaft sensor to ecu. someone have change the connector of the CPS now the ecu wires color are different to the CPS connector. thanks
  7. Lucas Gems Engine Management ECU pinout

    Range Rover Mark II / P38
    Lucas Gems Engine Management ECU pinout https://blackbox-solutions.com/shop/help/SM001.html
  8. EAS Air suspension ECU pinout diagram

    Range Rover Classic
    All-- I've been have a few issues with the air suspension on my 'newest' 1995 LWB, so I thought I get back to basics on what the ECU should be doing. So after a few hours of reading the electrial troubleshooting manual and attempting to make sense of the shop manual, attached is the full pinout...
  9. BeCM pinout?

    Range Rover Mark II / P38
    Hi! The time has come to install a speedometer calibrator on my '99 P38 and looking at past threads here and on other forums I see that I can splice in between ABS ECU and BeCM one. The question is - which wire? I have Rave but all it shows are connectors with wire colors. I could not find any...
  10. Anti Theft to aftermarket keyless conversion - harness pinout

    Range Rover Classic
    Anti Theft to aftermarket keyless conversion - harness pinout I am in the process of installing keyless entry unit on a 1993 LWB. The vehicle had the original Anti Theft module which I am replacing. Looking at the two copies of RAVE I have, I could not find the anti-theft wiring information...
  11. SRS / Airbag ECU pin-out ?

    Range Rover Mark II / P38
    On a '95 P38A - the [big yellow] SRS ECU with the 30-pin red connector, sometimes called the MPS1, also AMR4905, with the two crash detectors behind the grille.... and described as the 'distributed' and/or 'multi-point system'. Anyone know the exact pin-out designations for this - or actually...
  12. 1995 RRC NAS Alarm connector pinout for those wanting to go aftermarket

    Range Rover Classic
    1995 RRC NAS Alarm connector pinout for those wanting to go aftermarket All-- Just spend the afternoon digging through Rave and playing with wires to figure out how this fartory darn alarm system works. Here is the result, it is accurage, enjoy... and I hope it saves someone else a bit of...
Top