Here is episode 3 of 6 on my complete restoration. This episode covers bodywork and primer.

2015 RR HSE I'm trying to disable the intelligent start/stop. I've read through all the threads and understand about disconnecting the negative terminal on the battery. The problem is, I can't figure out how to remove the panel to access the fuse area. Can anyone advise me? Thanks much

I tried removing it by hand when I first bought the car and failed. Yesterday, I tried using some sturdy interior trim removal tools on each side and it budged a bit, but I was still was not able to pop it out. Haaaalp?

I have a 2009 RRS SC and I'm trying to rid the truck of rattles. I have the usual tailgate ones which I have found solutions for but I have not found any solution for my sunroof rattle. If I have the sliding shade closed it rattles loudly on uneven roads. If I partially open the panel the...

Does anyone now if its possible to replace just the speaker mesh in the door panel?

Hey guys. I just received my 2019 Range Rover HSE. So far so good (one minor infotainment blip) that reset itself. My question is on the steering wheel controls where you can set to see your media playing by the speedometers do you guys have a color background at all? I could have sworn I used...

Hello All, So I was deep cleaning the p38 and while I was messing about in the passenger kick panel I found these mystery wires. 3 are cut and taped up and one more goes down to a small splitter there's a line coming from the splitter that is also cut and taped up. Any ideas? Perhaps an...

I have spent a fair bit of time searching posts without success for the colour code, assuming there is one, for the dashboard and instrument panel. I have the dash apart to replace the blend motors and would like to freshen up the panels. To me it looks like matte charcoal, as opposed to...

Hello, Does anybody have an idea, how to switch the instrument panel language from Romanian to English for (Range Rover Autobiography L405) Thanks a lot

hello, I'm trying to remove the front panel from the door but it doesn't unhook on the speaker side. Is there an additional screw in that area? Should the speaker be removed first? Does anyone have any step-by-step guidance on how to remove the panel? thank you very much.

I need to remove the rear floor panel as the fuel line from the pump to the filter has corroded and is leaking. Is the panel riveted or spot welded? i am away at the moment so that’s why I can’t check on the vehicle thanks for any replies

My interior door does not attached with a tight fit due to 7 of door studs do not hold. I have replaced the door studs and the stud retainers in the door with no luck. Same result even with new stud retainers. I have tried to fill the holes with body trim rivets with little success. Has...

As it happens with age, the wood trim on the door cards of my classic seemed a little too loose, I attempted to remove and the metal clips encrusted on the veneer wood had come out of the wood. I searched for options but nothing too viable surfaced. in order to attach the metal clips back onto...

Wanted to replace my cabin filters as they have done the usual turn to dust - removed two screws but need some help on getting the plastic castings out. They are stiff and I know there are clips but want to be careful of cracking them. Any thoughts tips or photos of them removed to guide my hand?

Cruising at 80mph, high West Texas x-wind blew off the pax-side A-post trim panel, broke three of these clips. I find dozens of different RR panel clips, but not these. Any source?

Guys, I was installing auxiliary lights and I accidentally blew the main fuse/fusible link that feeds the rear fuse panel (rear passenger side in cargo area). The rear fuse panel has no power. I am trying to find the location of the fusible link that feeds the rear fuse panel. I have been...

Hello all. I'm new to RR but owned an awesome 99 Discovery for 6 years we put over 130K miles on after we bought from original owner. Did all that with only 4 minor repairs!! Only sold her because after 3 attempts and even a local "best of" shop high bill, we could never get sunroofs to stop...