p0011

I have replaced the camshaft position sensor but I am still getting this code, it is the only code shown after diagnostics, car runs fine except that sometimes the idle is too low it stays on the first line after 0, this is with A/C off with A/C it goes a bit higher to almost normal idle. has...

I've heard some bad thing about this code. The range we are working on currently has 92300 miles We've rebuilt the engine, and originally we had 2 codes, 1 was the O2 Sensor, so we replaced all 4, engine light is now clear. However, when scanning with a OBD2, Currently getting a "pending...

04 L322 with P0011 and P0021 Codes after Vanos and Timing chain overhaul with a twist. I bought the car with what I thought would be a fairly easy Vanos repair issue. Many, many $$ later I have the same codes. The twist is that two shops now that repair BMW and Land Rover have tried to get it...

Hi just replaced timing guides and timing chains put it all back together and receiving the codes above, it starts without a problem, ticks over fine and drives ok. The only problem seems to be what sounds like a really bad blow on the exhaust. Is this likely to be associated with the codes...

I've been reading about this for days, and finally decided to make the thread to see if I can get any ideas on this. The car ran fine, no codes, no check engine lights. Then one morning I start it up- it rattles REALLY BAD for 5 seconds, then stops and drives fine. Through out the day - it...

This code just showed up, my car does not have any of the symptoms that would trigger this code, as a matter of fact this is the best the car has performed. I am perplexed at the amount of $$ other owners have spent to get rid of this code. Should I be worried by this my car has 125K it is...

So i purchased this suv about a month and a half ago.. had it in a shop for a month before it had the code p0012 and the other one i cant remember but the suv felt strong and responsive but it has rattling very bad took it to the shop they said all my guides were broken and tensioner's were no...

Well today My SES light came on, Camshaft position over advanced. Looks like this could be a very, very expensive and involved problem. So it looks like my choices are: 1. Have my local Indy fix it. Assuming the worst case scenario, I'm looking at 3-4k for timing chain guides, chains, and Vanos...

Here is a question or poll... Has anyone had a car starter that cause an engine code to pop up? Or any engine related issues after a remote starter has been installed? Got a 2004 L322 HSE with BMW M62 engine. Timing everything seems to be fine, car idles and runs fine. It is a bit loud during...

Can wrong oil weight viscosity cause P0011 and P0021 on cold start up? Recently rebuilt my 2004 Range Rove (M62 BMW engine, cracked intake cam, bent valve cylinder 8) used timing tools, refaced the heads, replaced a bunch engine components, etc... About 1 in 3 COLD start up, the engine will...

OBD II code P0011 Intake camshaft position timing over advanced I searched the forum for topics discussing this and was unable to come up with anything. 2003 HSE, 130,000 miles. Has anyone dealt with this and successfully solved the problem? I did a little bit of googling and there are...