RangeRovers.net Forum banner


  1. Needing to improve drivetrain and engine in 85 classic

    Range Rover Classic
    I'm trying to make my 85 2 door a reliable daily driver. Its a 3.5 with good compression but uses a lot of oil. It has been fitted with a 600 cfm 4 bbl Carter but I still have the strombergs if Ineed to go back. There is a lot of play in the diffs and the gearbox leaks oil. Yep I have some work...
  2. P38 overheating issue

    Range Rover Mark II / P38
    Hi All,Recently acquired a 1998 P38 HSE. Loving it, but..... got an overheating issue I could do with help on.Long story short, I think I need a new radiator, but would like to confirm before I start throwing cash in.I've spend a bit of time on diagnosis using RAVE and online resources, and...
  3. P38 Needing an engine - which one -

    Range Rover Mark II / P38
    Hello, I’m a newbie here. I just bought myself a project as it seems. It is a 2002 P38. It is running a bit rough with multiple misfires. I took it to my mechanic last week and found out cylinder 5 has no compression. The mechanic dug a little deeper, he removed the head and found that cylinder...
  4. New guy here needing help with engine surge in 2010 RR

    Range Rover Mark III / L322
    I purchased my first Range Rover, a 2010 full size HSE. Love the truck but one this is bugging me big time. When driving on the freeway and I reach about 1800-2200 RPM's there's a surging in the RPM's. So strange. It is fine up to and even after, but then I'm going upwards of 75 mph. Not sure...
  5. newbie needing help with wiring issue :)

    Range Rover Sport / L320
    Hi folks, just bought a RRS L320 v8 and Im having some Issues with wiring! Namely the driver side wiring loom that runs up the A Pillar. Mine has been cut just at dash level and I have no idea where the wiring goes :( has anyone had this trim off or able to point me in the right direction as to...
  6. Air suspension problem needing advise

    Range Rover Mark III / L322
    Hello Folks,just wanted to ask about an issue I have. 2 mons ago I heard a hissing sound on the front passenger side and from then on I had issue with the air suspension problem-not maintaining the height (while driving and parked) I can hear at that time the back compressor is working to...
  7. For those of you needing a tool set

    General Chatter
    No connection to Sears. I have this set and it's quite good. Half price right now: http://www.sears.com/craftsman-230-piece-mechanics-tool-set/p-00950230000P?sid=IAx20091026x000001&aff=Y&PID=806314&AID=11042411
  8. needing help finding part number

    Range Rover Mark III / L322
    I have searched up and down trying to find a part number for the oil drain pipe assembly. Its the metal tube connected to the oil pan and connects to oil seperator.can anybody help . Please.
  9. 2012 RRS supercharged needing head gaskets

    Range Rover Sport / L320
    Have had engine light and coolant light on and checked and topped off several times. Now they say need head gaskets after injector replacements and rough misfiring. Anyone else had this issue? Not a ton of miles on it.
  10. Needing advice on EAS fault codes

    Range Rover Mark III / L322
    have a lynx diagnostic kit for range rover and plugged in as the air susp is in active, changed the air suspension bag and now tried resetting found the following fault codes.. 122 RESEVOIR PRESSURE RISES WHEN LIFTING.CURRENTLY PRESENT 103 TOO MUCH ENERGY FOR REGULATION NEEDED. FRONT AXLE...
  11. ABS needs replaced? Complete ignormaous needing help

    Range Rover Mark II / P38
    Hi, I have a 2000 reg 2.5 DHSE Range Rover, which has just failed it's MOT. I've been advised that the garage think I need to replace the ABS, but are getting a 2nd opinion in case this is cost prohibitive. I have no idea what they mean, nor do I know if I can run the car without ABS. I am...
  12. Suspension Fault (Yellow) C1B03-19

    Range Rover Sport / L320
    Okay guys... Long time member needing a little help here... I have a suspension fault that comes on just about every time I drive now. The suspension fault is yellow and the code is C1B03-19 (Active control module directional control valve 1 circuit above threshold). Took it to the dealer...
  13. 09 RR TDV8 - Turbo Actuator is needing replaced

    Range Rover Sport / L320
    My RR recently started getting "Engine System Fault" messages when you started the engine and also low rev power was down a lot so I finally got it in to a dealers garage to find out they think the turbo actuator needs replacing and it will cost £900 odd inc vat. Just wondering if thats a fair...
  14. i'm a new member with a 2008 rangerover sport (supercharged) with brakes needing

    New Member Introductions
    i'm a new member with a 2008 rangerover sport (supercharged) with brakes needing i'm a new member with a 2008 rangerover sport (supercharged) with brake pads that need to be replaced, so i'm hoping i can get some help from this site `8)
  15. Needing replacement key for 06 RRS S/C

    Range Rover Sport / L320
    Sold my 06 RRS yesterday, and can't locate my spare key. Does anyone know where I can buy one online? thanks in advance!
  16. 2002 range rover needing to finally go to coils

    Range Rover Mark II / P38
    Anyone have suggestion on what coil conversion kit is best? Should I change out shocks as well? 130k miles. Also anyone near Pittsburgh Pa that can do the work?
  17. hi new member needing advice with possible becm fault

    Range Rover Mark II / P38
    Hi need some advice from anyone knowledgable with the becm. I have an intermittent problem on my P38 dhse 2000my. It seems to loose a power feed which means the sunroof and all windows need to be reset and the radio needs it code. I havent found it yet in the state of the supply missing, just...
  18. New Member Needing Help!

    Range Rover Mark II / P38
    Hi all a big hello from the south east hope you all are well :) sorry to drop this on you straight away but i have a P38 xreg 2000 model 2.5 DHSE ,Problem leave the car and it sits on the floor will not raise up but if i jack it up it will stay there :?: and you can lift it up and down ok cant...