RangeRovers.net Forum banner

neck

  1. Swan neck tow bar

    Range Rover Mark II / P38
    I have what I assume must be the standard P38 swan-necked tow bar on my RR. I can remove the massive M20? bolt easily enough, but then like most things on the back end of this vehicle new to me it does not want to move. From what I can see in photos it was just the main bolt holding it in, with...

  2. Diesel fuel filler neck blocks diesel pumps too?

    Range Rover Sport II / L494
    I had filled up my new Td6 twice with no issues. Today, however, I drove past a different fuel station and found that their diesel pump did not fit. I then went to another station and it too did not fit! I happened to be driving past the original location and filled up there, but I'm rather...

  3. Split oil filler neck (noticed while tying to sort cooling)

    Range Rover Mark II / P38
    Had the top hose go a few days ago, had it all apart and trying to get a suspect air lock out of the cooling system (see other thread!) and noticed the neck of the oil filler that the cap screws into is split. The whole neck thing unscrews and i can see that almost all the way up the fitting is...

  4. Filler neck to body grommet

    Range Rover Mark II / P38
    After 191,000 miles, the fuel pump finally needs replacing in my 1995 4.0. I am using the directions on here for saving the original assembly and swapping in a generic pump. Waiting for parts to finish. However, in removing the filler neck from the body work, the large grommet (ESR3027) was...

  5. Oil Filler Neck O-Ring / Gasket

    Range Rover Mark II / P38
    Hello to you all. Does anyone have an idea where I can get the O-Ring/Gasket that goes on the oil filler neck where it sits on the valve cover? I have just found searching the neck with the ring for USD $80.00 or used for USD $25.00 ... Of course for this I will like to get a new...

  6. P38 petrol fuel fill neck pipe size

    Range Rover Mark II / P38
    Hi Does anyone know the internal diameter of the short pipe which joins the fuel tank to the filler pipe? I need to take my tank out again to replace a new faulty fuel pump (Britpart) and I do not want to wrestle with the old hardened rubber pipe again and instead will replace it with a...

  7. Coolant neck pipe on cylinder head 2.5 dse BMW engine

    Range Rover Mark II / P38
    As a follow on to my overheating/coolant loss woes....I now know that the aluminium pipe I have to replace is a seperate part from the cylinder head casting.Although it is not available to buy from stockists (ludicrous). But who knows how the hose neck is fixed into the casting?..Is it just a...
Top