RangeRovers.net Forum banner

movement

  1. Front Prop Shaft movement 95 RRC LWB

    Range Rover Classic
    Just finished replacing the viscous coupling in my Range Rover classic. I installed the front output flange with the big nut. Torqued that down to specified torque (a lot!). Installed the front prop shaft and noticed some movement in the shaft when I grab the end closest to the viscous coupling...
  2. Electical issue with driver seat & steering column movement

    Range Rover Mark III / L322
    Electical issue with driver seat & steering column movement Basically, both steering column and driver seat controls are inoperable. I removed the multi-plug from under the driver seat and discovered that no power is registering on pin 13. (red brown wire). Passenger side had power on the same...
  3. Range of movement on telescoping column

    Range Rover Mark II / P38
    Good afternoon all. Whilst working underneath the dash I appear to have dropped a bolt that landed in or around the lower steering column area. It does not appear to have dropped to the floor sadly. While moving the column out of the way, the telescope adjustment does not seem to move as far...
  4. Drivers seat movement

    Range Rover Mark II / P38
    So my new to me P38 is in very nice shape and I'm trying to do all the things needed to make it close to perfect. I know, not for the faint hearted. Anyway, the drivers seat leather is going to be redone and I notice that the seat rocks on acceleration and braking. It's not dangerous, just...
  5. 2001 RR Drivers and Passenger Seat movement issues

    Range Rover Mark II / P38
    Search isn't my friend in this case. On my 2001, the drivers seat and passenger seats are functional except for the front portion of the seat cushion will not lower (they are both raised in the highest position). All other movement functions work perfectly, which is what is confusing. Anyone...
  6. Air Suspension Light Flashing- No Movement.

    Range Rover Mark II / P38
    Hi All, Firstly, Happy New Year to you all. Secondly, Air Suspension! I had a problem early last year with the Air Suspension which turned out that the pump had stopped working. I had the flashing light on the central dash/switch area quite quickly followed by the and "EAS Fault" warning...
  7. Engine movement

    Range Rover Mark III / L322
    Hello all . I'm hoping somebody with a similar car to mine can do a little test for me please !!! Our car is a 2007 supercharged . Tonight I parked on the driveway which meant the front was about 6" higher than the rear . (Can redo on level ground tommorow if it helps) Whith the car running...
  8. 2006 (06MY) Temperature Gauge Movement

    Range Rover Mark III / L322
    Hi All, I've had some issues with my 06MY and the engine temperature. It's the non supercharged AJV8, and has only 70,000km on the clock. On a cold winter day (and in Australia that means around 5 to 10°C) I've noticed that the temperate gauge will start to drop from the normal vertical...
  9. '08 Full Size Steering Column Movement Hesitation

    Range Rover Mark III / L322
    Gents, I have a 2008 Full Size Supercharged I just picked up. I've noticed that my steering column randomly doesn't lower back into position. I see this is a relatively common issue but most posts are discussing the 2002-2005 years. Anytime it doesn't lower, if I manually lower it you can feel...
  10. Suspension movement

    Range Rover Sport / L320
    Hi, Strange issue with my 08 RRSport. Sometimes when i'm stopped i feel the suspension wiggle slightly, almost like it's trying to correct itself. It's only a little bit but it's a bit strange. Is this a common issue? Does anyone know if it's a signal that something is going wrong? Thanks.
  11. Question About Speedometer/Tach Movement

    Range Rover Mark III / L322
    We purchased a 2011 RR HSE two weeks ago (our first) and noticed on the TFT-LCD screen that the "needle" on the speedometer/tach does not move in an even sweep, it moves in small, choppy increments. Is this normal for this vehicle? Appreciate any feedback anyone can provide. Thanks
  12. RR L322 internal trim movement after harness replacement - should it have movement?

    Range Rover Mark III / L322
    RR L322 internal trim movement after harness replacement - should it have movement? Hi there, I’ve had a full harness replacement in my rr l322, there were a few snagging issues once it’d been done which are being dealt with but one issue that I’ve been told is 'as good as it gets' is the...
  13. Strange Driver’s Side View Mirror Movement

    Range Rover Mark II / P38
    I adjust and set my seat and mirror positions and store same as a memory position, I press the memory button again to make sure everything stored correctly, but when the seat and mirrors are moved, the ignition is cycled, I start up the truck again and when I press the memory button to retrieve...
  14. Late new vehicle delivery from dealer...EVOQUE

    Range Rover Evoque / L538
    I am facing some issues with my current Land Rover dealer. The salesman has been first of all, been annoying me for my "business card" to scan over, for internal audit reasons when I purchased my Land Rover Sport in late October. He inquired for this over 6 months after purchase. He harassed and...
  15. Lateral movement in swaybar causing clunk on bumps?

    Range Rover Sport / L320
    I just got my LCA bushings replaced on my 06 RRS S/C which stopped the slow speed mattress-creaking sound. Cool. I was hoping that it would solve the low-speed clunking sound I hear. Unfortunately, upon test driving the truck the mechanic said that I probably need a new sway bar because there...
  16. New Lca, should their still be movement in bushings.

    Range Rover Sport / L320
    Hey all i just got my LCA replaced 1 week ago and was checking them and realized that their is still play in the bushing when i use a wrench or my hand and shake the control arm bushing, i called my mechanic and he said all range rover sport bushings have play in them cause the radius thickness...
Top