Range Rovers Forum banner
mount
1-16 of 67 Results
  1. Range Rover Mark II / P38
    I’m working with my fabricator on a winch mount at the moment but some additional feedback is needed. If I remember correctly the ARB bumper on the D2 mount onto the crush cans so I should be fine bolting my winch mount on the crush cans? They won’t pull apart or deform with the pull from the...
  2. Range Rover Classic
    I purchased hitch mount spare tire carrier that has three welded studs which I believe fits a 5x4.5 lug pattern. My RRC has 5x6.5 and the spare won’t mount. I am considering bolting on a wheel adapter or having a fab shop fix it. Does anyone have any ideas or recommendations for wheel adapter?
  3. Range Rover Classic
    I want to put a couple crossbars on my ‘93 LWB using Thule rain gutter mount feet. They come in a few sizes- I want to go as low as possible. The two options are a 5” rise and a 8” rise. Has anyone had luck/clearance with the lower foot?
  4. Range Rover Mark IV / L405
    Anyone aware of any aftermarket companies offering either a front winch mount or underbody protection/skid plates for the L405 as of yet? Just installed lift rods and some 275/55/20s and would like to add a winch and some underbody protection before doing any significant off-roading. Also...
  5. Range Rover Classic
    Hello, I was working underneath the car when I accidentally caught and pulled a single black wire. One end is connected to the engine mount(left side) and so is grounded. The other end has a black plastic, 90 degree, female spade connector attached, with the word “Amps” on it. The wire is...
  6. Range Rover Sport / L320
    Anyone have experience with replacing transmission mounts? Should I go genuine parts or are there better heavy duty aftermarket ones? I drive pretty hard so something heavy duty would be nice.
  7. Range Rover Velar / L560
    I like ProClip cell phone holders, but to date on their website they don't show one for the Velar, probably since it's such a new model. I grabbed the ProClip dash mount from my Prius I sold in the past, and it fits perfectly in the upper left center air vent. I have been using it now for a...
  8. Range Rover Mark IV / L405
    Friends, I have asked Warn Industries to consider introducing a winch mount for the L405, especially since there are gradually more and more folks with used ones that are more likely to be used off road. I got a nice reply from Russell Smith, [email protected], saying of course there needs to be...
  9. Range Rover Mark II / P38
    Bilstein 7100 short body reservoir shocks & rear upper mount Switching to a Bilstein 7100 short body remote reservoir to maximize articulation and control the weight of the vehicle better and came across the problem. A short body shock (to get lengths that are appropriate) has a remote...
  10. Range Rover Mark II / P38
    Hi All, I have a problem with my UK Range Rover P38 1996 4.6 Auto The Crank sensor (CKP) is mounted through a plug in the bell housing. This plug (It transpired) was moving. This first caused a problem where on hard acceleration or when reaching a speed >70mph the car started to misfire...
  11. Range Rover Classic
    Ok. Here's a tough one. I'd like to mount a winch on my 92 County. I have a 95 bumper, and OE Brushguard. The kicker is I also have a Rovers North steering guard mounted as well. So...where do I mount the winch? Originally I had intended to mount the winch behind the bumper and hang it...
  12. Range Rover Mark III / L322
    question for the experts here... I have a broken motor mount bracket. is there anyway to change that doesnt involve separating body from frame? I have the 4.4 jaguar motor.. 2006 thanks for any input
  13. Range Rover Mark III / L322
    So I'm looking at buying a radio. Probably a higher wattage SSB CB. Not sure which model yet, still researching. What I would like to know is: Where have people mounted theirs in their L322? Pics? Also, did you wire into an empty fuse or are you piggy backing off of something for the power...
  14. Range Rover Mark IV / L405
    Outstanding Campaigns Anyone knows what this is about?
  15. Range Rover Sport / L320
    Hi All, Are there any posts (I have looked and have not found) with instructions on how to replace the drivers side motor mounts? Does it slide out or do I have to do some crazy removal like with the trans pan? TIA.
  16. Range Rover Mark III / L322
    I should start with I have an 2008 HSE. So I'm looking at a phone mount. So far, the best looks like the pro clip linked here: http://www.proclipusa.com/dashboard-mounts/vehicle/land-rover/range-rover/2002-2012/proclip-center-mount-high-854085-13131.cmsv My question is has anyone installed...
1-16 of 67 Results
Top