Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-15 of 15 Results
  1. Range Rover Classic
    Need location of all brakepipe connections. Anyone with the ANR1118 Wabco ABS modulator ( with ETC) and right hand drive. 1992 to 1995. The RAVE workshop manual doesn’t show clearly. Cheers in advance.
  2. Range Rover Mark II / P38
    Ok, i have searched for days and have not found any info on this so i am throwing this into the mix. I have 2001 P38 which was sitting for a couple years. I got it back up and running with a little work. The ABS system was completely Garbage as i started going through it piece by piece. So...
  3. Range Rover Mark II / P38
    Hey, everyone. My 1998 4.0 has the dreaded brake pedal click of death. I know Range Rover Solutions used to sell a BMR kit to upgrade the failure-prone plastic washers inside the brake modulator to stainless steel. I do not see a purchase option on their page (nor a price) for the kit. I have...
  4. Range Rover Classic
    Last week I stripped down a donor Modulator, to see how they work essentially. Are there any rebuilt kits available?
  5. Range Rover Classic
    Been helping reassemble a RHD '95 soft dash that has been completely stripped for restoration and have run into a problem. The ABS modulator had been taken off along with some of the brake pipes. Now we are trying to work out which pipe goes into which port. RAVE says that all ports are...
  6. Range Rover Mark II / P38
    Hi. I want to do the following query; My P38 1996 with Control traction on the rear wheels, is giving problems modulator, the braking hard it gets hard and violent brakes, but when braking soft or normal, this becomes very soft, according to a specialized brand mechanical, it is a bi-directional...
  7. Range Rover Mark II / P38
    Hi everyone. I hope you can help. I fitted a new abs modulator and now have a few issues. After bleeding all was fine tc light went out. Abs light went out. Went for a drive and after 15 minutes lights came on and abs tc fault on dash. Then when I turn the ignition back on I get a loud ticking...
  8. Range Rover Mark II / P38
    Brake Modulator R&R Stainless spacer repair Russell's Kit I am a worrier. Every time I drive my P38 I think "is this the time the brakes are going to fail?" I love the rig, it has 162K miles, engine is decent, no rust, interior good. I want to keep it, but I'm sick of worrying about the...
  9. Range Rover Mark II / P38
    Hi all, Have been reading about the brake modulator with the problems with the early ones with the plastic park braking and no brakes as a result. Rather than buy a new one at £3,000 or whatever it is from Land Rover, has anyone successfully bought a second hand one from a late P38 and put it in...
  10. Range Rover Mark II / P38
    Hi, curious if anyone can provide the pin outs for the abs modulator? They don't seem to be in my version of rave, and I've had no luck in searching. I'm looking for the 99 to 02 with 4 wheel tc. I have the outs for the ecu. Just need them for the brick. Thanks in advance for any help
  11. Range Rover Classic
    Hi all. Got an ill Classic in the workshop. The front brakes intermittently stay on and the lights on the dash show. I'm pretty sure the modulator is the issue as nothing shows on diagnostic to support an ABS ECU or wheel speed sensor issue. The brake lines and fluid have been contaminated...
  12. Range Rover Mark II / P38
    I had to change out my ABS modulator yesterday because the master cylinder failed. Followed the RAVE bleeding procedure, skipping the caliper parts as they weren't touched. Now when pressing the brake pedal, it's pushed back against my foot full force. I have to really feather it to have any...
  13. Range Rover Mark II / P38
    Hey Guys, Wondering if it's possible to replace the pesky and expensive brake modulator with an old school vacuum boost brake system? ... or upgrade to a newer more reliable and less expensive LR modulator fitted on their newer vehicles? History - Been suffering with a stiff pedal when the...
  14. Range Rover Mark II / P38
    I've seen some really ancient threads on here about replacing the plastic piston parts in the early 95-99 abs modulators. I cannot seem to find any supplier for these kits. Has anybody encountered a supplier as of late or is it time to drag out the machining tools? On a 600mi roadtrip...
  15. Range Rover Mark III / L322
    Hi All, This is a follow up to my previous request for help bleeding the brakes om my l322. I am sure that I have bled all the air out of the system but when the engine is running the pedal slowly sinks to the floor. Rave points to the ABS Module needing bleeding but say this can only be done...
1-15 of 15 Results
Top