metal

I have a oil pressure warning light stop engine. I’m getting p0012 and p0345 codes and multiple misfires on 5-8. Truck did overheat. I changed oil and filter. I was having a coolant issue with antifreeze pressure overflowing back out the resovoir or top radiator hose when disconnected. I...

NEWBIE Join: 11 minutes ago Posts: 1 half a minute ago · #1 06’ l322 owner Hello RR community. Thanks for the add. I am the owner of an 06’ l322 full size with 2” Johnson rods I installed. I see everyone has installed larger tires as I plan on doing with varying dimensions, however.... I see...

Hello all, I'm new to this forum and fairly new to Range Rovers in general - just purchased a 2003 Range Rover Sport HSE (143,000 miles). The only non-maintenance related work prior to purchase was the replacement of the front driver's side air strut with an Arnott replacement (but the prior...

I have taken the car to a local specialist who hooked up the computer. No obvious messages. The engine can start immediately without a problem or hesitation - you can start stop 20 times without fault. No problem with the battery or starter motor. On other occasions the car doesn't start or try...

Last night I started my car up to move it and it made a weird metal clicking noise but it dosent do it always this morning it was gone. I had the timing chain tensioners and supercharger coupling replaced two months ago don't know what the sound is included a clip of it here

Hi everyone- i'm new to post in this forum but I've read just about every post in regards to front end noise. I have a 2011 RRS with 60,000 miles. I have a metal clanking in the front driver side wheel when hitting a sharp bump at low-speed. I have replaced the lower control arms - sway bar...

Good day to all in this very helpful forum. I'm not sure if I have an issue with my rear diff or not. I haven't been able to find much help in the forums relative to my issue so I thought to post here. I would be very appreciative of any insight. Story below. v/r Michael I have a 2008 RR full...

I would like to replace the polished trim strips in my side moldings. I had done a search the other day and found a mention that someone on the forum had replacements available. I am unable to locate that thread and not sure if that person is still a member of the forum. Any info appreciated...

Has anyone swapped out their interior aluminum trim to the grey oak or piano black? If so, please let me know the process and cost involved. Can it be a DYI project or does it need to be done by the LR dealer? All input is appreciated!

Hi guys, just wanted to share my experience as far utilizing a metal transmission pan from Atlantic British. I have decided to replace all fluids troughout the power train (less engine oil as that goes on it's own schedule). While transfer case and differentials are fairly simple, transmission...

Hello all, Corrected the few small issues that I previously had with my RR thanks to you guys here at the forums, however now I have a new issue, and I'm still being just as pedantic as ever. `) My interior air vent shiny adjuster thing has gone missing, somehow I didn't notice it was missing...

Just got my truck back from the service dept at the dealership after two weeks of them trying to determine the reason why I heard metal on metal rubbing noise when driving and sometimes I could hear metal rattle around going over bumps at low speeds. After the first week the service advisor...

From the same Chinese supplier that brought us the window switch trim, here are the seat switch covers. Very nice quality and perfect fit. Hopefully the tape holds. I didn't care for more chrome with the window switches, but this is very subtle and seems like a nice touch. Not sure why my...

It's hard to explain, but it seems like it is a sort of rolling (metal on metal) noise from the rack-and-pinion steering mechanism I think. You only hear it when making a corner to the left (drivers side in Europe left). The sound gets worser when driving faster, when parking too but not always...

I have reassembled my p38 after replacing the heater core and found the clip below (see photo) not replaced. It's probably in the center console. Can anyone tell me where it goes and what it does so I can determine whether or not to do the work to replace it. Thanks

'94 RR County LWB 4.2 Please help me diagnose this noise: rattling noise, quickly growing worse, passenger side, front end. Noise only under load. Completely stops if I take my foot off of accelerator, and seems to stop if I punch up the gas a little. Noise is very loud under freeway speeds...

Hi All, In response to GooseyLoosey’s question from another thread re the metal pan replacement ZF transmission pan I thought I should start a thread of its own. The pan is available from Brit Parts, if you fill in their price enquiry the distributor in your area will contact you with price...

Can anyone describe how to get it off? I read a drift and hammer but still cant figure it out. Thanks

I have an '04 RR L322 and the exterior black metal trim at the four corner posts of the cabin is faded. Does anyone have any suggestions to restore this trim before I go the repainting route? Stuff like Back to Black doesn't work because there is nothing for it to soak into. Thanks.

Hello all I've got a question about the front suspension on my 02 P38. There is a knocking sound that I hear predominantly on rough ground, as well as a metal clanging sound. I really don't know much about those parts down there so I will post pictures of what things are looking like. I...