RangeRovers.net Forum banner

melted

  1. L322 navigation plug colors in trunk mine melted

    Range Rover Mark III / L322
    HI I got water in the trunk and fried the silver navigation module and melted the plug got a new plug and nav silver module the problem is I don't know the colors to the pins, willl tale you five min to take a picture of the plug going into the silver box so I can match up the colors thanks in...
  2. compressor plug melted

    Range Rover Mark II / P38
    The title says most of it. I haven't really used my range this summer because I've been too lazy to rebuild my burnt out compressor. Well I finally got around to doing so but when I reinstalled it I couldn't get it to run. Upon closer inspection I found thisClearly I need to replace the plug but...
  3. Plastic melted within the headlight

    Range Rover Mark III / L322
    Hi guys! I was wondering if anyone has the same issue as I do (see photos). The plastic rim around the cornering lamp has melted on both sides, could it be a fabrication issue because I've never changed the bulbs in that area... I have a Range Rover L322, MY07, 3.6 TDV8, 142.000 Km (88.234 mi)
  4. Heated windscreen fuses melted

    Range Rover Mark II / P38
    First frost of the winter and I push program on Hevac, heated windscreen not working. So that evening, as a first thing to try, I look at fuse 30 and 32, both melted! Thankfully, I have 30 amp spares, so I install them and run the heated windscreen for a while. All is now good. Now what's...
  5. Door outstation melted

    Range Rover Mark II / P38
    Hi My name is Lech. I bought Range Rover '96 P38 about 2 weeks ago. Today i was fixing locking for both front doors. Everything was good till night. At 8 pm alarm turn on so i went to saw what is happening. Then i saw smoke in a car. I quickly disassemble front left door, because smoke was...
  6. melted relays wont start

    Range Rover Mark II / P38
    I have an 02 p38..I took it to the beach yesterday..about 120 miles 1 way..got in to start it last night and nothing..checked the relays and sure enough most of them are warped and melted. I switched out #19 with a non melted one since I know from previous times this fixes the problem...
  7. Overheated and melted wiring blows F15 fuse

    Range Rover Mark II / P38
    Fellow enthusiasts, I recently purchased a P38, at a discount price, and one of the problems with the vehicle is that 20A fuse F15 fuse blows as soon as it is inserted. With the aid of the Electronic repair manual (page 7 of Y2 very relevant), I have traced the problem...
  8. Fog Light Bulb Melted into Housing?!

    Range Rover Mark II / P38
    Hello all, I got a warning on the message screen that said bulb failure, left fog. So I check it out and the bloody thing is smoking! After that was sorted I tried to get the bulb out of the housing itself and this is what I found After the main part of the bulb came off, I was left with the...
  9. Shop light slightly melted the air intake hose - will I be able to tell?

    Range Rover Mark III / L322
    Shop light slightly melted the air intake hose - will I be able to tell? Hi all, Foolishly I let my shop light tip over and sit on the air intake hose while I was doing some re-assembly of the air cleaner/filter housing. After about 15 seconds, I looked over and saw a tiny bit of smoke...
Top