Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-14 of 15 Results
  1. Range Rover Classic
    I have downloaded the RAVE, but haven't dug far enough into it to be able to locate how to turn off the immobilizer. I'm working with a neglected vehicle and I have no owners manual for a 1994 Classic. If anyone can point me to one, I sure would appreciate it. I've got two remotes. When I hook...
  2. Range Rover Classic
    Hi there, anyone with good ideas on how to permanently fix the bonnet locking mechanism on the RRC? I've grown tired of having either bonnet pins or rubber straps to keep the bonnet in place and that keep on breaking or releasing when going on rough roads (of which there's plenty in Kenya)...
  3. Range Rover Sport II / L494
    I own range rover sport super charge model 2014, this vehicle run into accident so the air bags came out both of them. I have finally repaired the vehicle Know the question I wanted to purchase a new air bag for the time being for the driver, but the problem someone told me that I have to...
  4. Range Rover Mark II / P38
    Hi All I have just installed a new drivers side door latch in my RHD Australian delivered 2001 4 litre. It was nowhere near as difficult as I was expecting, albeit due to tips picked up here ! One issue remains to an otherwise perfect result. The pesty clip that we all struggle with that...
  5. Range Rover Classic
    I'm in the midst of replacing the rusty mess that is the glass tailgate frame on my 92 Classic with the Masai kit. I also purchased a new handle since mine was missing. So far so good but... I can't figure out how the pin in the middle of the handle interacts with the center of the rod...
  6. Range Rover Mark III / L322
    Hi. My steering column is stuck in the most retracted position. Tilt works fine. I have managed to take off the plastic housing around the steering column, and the black plastic trim above the foot pedals so I can have a better view. I have looked at the post "Steering Column telescoping...
  7. Range Rover Mark III / L322
    Well this is a lovely safety hazard! Lets hope i don't roll it on its side and can't get out! How do I get the door open to work on it? The vehicle starts and operates normal; I assume this means i'm not superlocked, therefor why can't I pop the door open by leaning over and pulling the...
  8. Range Rover Mark III / L322
    So when my wife's L322 is locked her fuel door does not lock. The mechanism moves in and out manually. Is there a specific fuse I need to check for this or actuator?
  9. Range Rover Mark II / P38
    Hello All, I have a bit of a problem here on my P38 HSE and need some help. I pulled my door apart to replace broken door cable (for internal handle of front left door). However, while pulling the mechanism out, I lost track of most of the other cables to the latch (ie the exterior handle...
  10. Range Rover Mark III / L322
    Hi, I have been meaning to fix the reach pert of the system for the steering adjustment for some time but now find I am forced to address it because the tilt went 'floppy' before jamming at the lowest setting. Preliminary investigation with a mirror reveals that it looks like there is a breakage...
  11. Range Rover Mark III / L322
    Hey everyone I'm having some trouble with my Rover so I decided to ask you all here to see if I can get some help. I have a 2003 HSE that only has a key hole on the driver side door, unfortunately about a year ago this stopped working. I can unlock and lock the door using the fob and the button...
  12. Range Rover Classic
    Lubed and working door locks! Now, my power door locking mechanism works too! Hello everyone, I apologize ahead of time if I'm wasting people's time - i couldn't find a previous a post, so I'm creating this. :| A while back I responded to a member who had posted that he was having problems...
  13. Range Rover Mark III / L322
    L322 Steering tilt mechanism second nut - any body know the tread size? I read the nice description on how to fix your sticking tilt mechanism which suggested a loosening of the nylock nut and addition of a second nut. Anybody know the thread size? What about two lower height nuts (get rid of...
  14. Range Rover Mark II / P38
    1996 P38, reassembly after doing the Audi Heater core swap. Having trouble with the glove box open/close mechanism... I believe that I've got the latch button cable hook in the right position - it moves back and forth EVERY SO SLIGHTLY when you press the button, but I've tried everything to get...
1-14 of 15 Results
Top