Search Results for ‘master’

Hi Everyone, I have a 91 RRC that I replaced the driver side brake caliper and hoses on about a three months ago. Bled the system with new fluid and everything seemed fine up until today. I drive a lot of highway miles and when I don't use the brakes for long periods the peddle gets soft and...

can anyone please advise how to remove the top single electrical connector on the master cylinder many tanks martin

Hi folks, here´s another addicted to" not so perfect" cars. like many English products. But its still nice to drive behind. All my friends drive Mercs and porsches, but I stick to my Rangie plus smart (which is in fact built in France!) The Healey 3000 and Jag E FHC are awaitig completion in the...

Hi Hard Dash 3.9 Non ABS 1993. Found a small pinhole leak in the vertical brake line running down from the master cylinder to the flexi hose so replaced it, also replaced all the bleed nipples on the car as some were looking like they were going to be challenging to remove in the future...

Does anyone know of someone who really knows the m62 engine inside out because I have a running problem with mine! When driving along the car is fine but when you come to a hill and put your foot down a bit more there is little response and the box has to change down. There seems to be very...

Hi. I’ve been replacing almost all of these small lightbulbs in the switches, the green and orange ones. The bulb in the master light switch eventually broke and I assumed it was a small green one like the others. Turns out it wasn’t. Does anyone know or have seen this type of bulb before? It...

Hi Guys, I changed front and rear calipers and brake hoses and unfortunately I let the master cylinder get empty. I have a power bleeder and I understand the normal order is: right rear, left rear, right front, left front. However, before I do that, what other steps do I need to take? Do I...

Thank you all in advance. I have had my poor RR 2002 HSE 4.6 On Jack Stands for 1month trying to get to the bottom of this, Started out with hitting brakes and almost not stopping,. like the brake pedal was hard, but it took a while for it to find a niche and then the pedal went down and the...

Today i replaced the drivers door handle cable which had broken a few weeks ago. A bit of a chore to be sure since I left the window down before I disconnected the battery so had to release the glass and after removing the speaker I could release the front and rear clip.:oops: Handy to have...

Good Afternoon All, Did I see on the forum that there is a master cylinder rebuild kit for my brakes? If so where would be the best place to buy? Thanks in advance Gary

Hi, this is a little embarrassing but how does one remove the strainer in the master cylinder. On other cars they typically just lift out but I can't get the one in my P38 out, is there a trick to it, I don't want to force it if there is a clip I'm missing somewhere. It's very dirty so I'd like...

Finally my restoration project is coming to an end. Only problem left is brakes. At the time i bought the car brake pump was not working,fixed it.Now the problem is; sometimes in traffic when i press brake,pressure goes down almost to 0 for a second and pump kicks in right away. Still...

Hello All! First time poster! I will introduce myself formally where ever I'm supposed to soon. I have an '87 Classic with a Mercedes OM617 Diesel. My issue: I am having trouble getting good brake pressure. I can't stop it without the e-brake. I have the Lockheed brake master cylinder and I...

Is it possible (outside a dealership) to perform a StaNav master reset?