Search Results for ‘machine’

Been trying to find a good machine shop in southern California to rebuild 5.0 non sc block and heads. Everyone I call runs for the hills when they know it is out of a range rover. I have the engine out and stripped just need to find a good machine shop. Any recommendations would be great

Hello all, I have a 1996 4.6 which I've owned for about 6 months now. Parts replaced as of 3 days ago: New AGM Battery, New 8mm Wires, New Spark Plugs The P38 started normally yesterday morning and I drove it to work. I tried to start it in the afternoon and it wouldn't turn over, the...

Had a weird event this weekend in my 2006 HSE. Went into a store Saturday with the wife, came out about 20 minutes later, and my radio had reset all the stations on the SAT radio to what they were when i bought the truck 6 months ago. Thought it was pretty weird, so I spent a few minutes...

I'm supposed to discharge refrigerant and release pipes to THX in order to remove fascia (according to shop manual). Do I need to buy a refrigerant recycling machine or can I depressurize, seal pipes and replace refrigerant when car can be driven?

I had my brakes checked at the Rover dealership. They told me that the rotors on Range Rovers cannot be turned. I will have to replace them. Can anyone tell me of you experience after Machining Rotors?

need to find local machine shop w/ 3.9l sleeve install experience Wondering if the community has any contacts in the DC/VA/MD area that has experience rebuilding 3.9/4.2/4.6 with flanged/tophat sleeves. I'm hoping to spend less than 5k, as it's hard for me to justify spending that much or more...

So, after many of the private messages I received asking how to install Microcat, I decided to produce a complete virtual machine with RAVE and Microcat installed and ready to launch. Before I release this for any forum members who want it, is there any other software that should be on this...