Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-18 of 55 Results
  1. Range Rover Mark III / L322
    Hi folks, Does anyone know whether it is possible to test the wiring for the front cross link valve? If it is possible how would you do it? do I have to remove the suspension ECU and check the plug pins and to the cross link valve? Thanks in anticipation
  2. Range Rover Mark III / L322
    Hi folks was taking a road less travelled at a slow speed the other day when the air suspension went into soft fault mode (air suspension disabled). Got back onto the highway parked up on the side and switched the engine off and then after a couple off minutes switched it back on and the soft...
  3. Range Rover Mark III / L322
    Hello, Does anyone know if there is a fusible link in a 2010 Range Rover full size? Reason I ask is someone replaced a fuse on a 2005 LR3 that was the issue he was having with a suspension fault code of C1A2714. I was wanting to check that fuse but I cant seem to find a fusible link. His...
  4. Diagnostic Equipment
    Hi all, I have a problem connecting code readers to my l332 vogue SE tdv8. I have two code readers that both come up with LINK ERROR on the screen when trying to scan through the OBD2 port. I have checked all fuses and nothing is blown, both these readers work perfectly with my other two cars...
  5. Range Rover Sport / L320
    Hey everyone! I'm new here. Own a 2011 Range Rover Sport HSE and I've had this odd noise coming from the passenger rear. It sounds like a chirping or pumping sound accompanied by grinding on occasion. Sometimes it's more prominent than others, sometimes I can feel the grinding underneath my...
  6. Range Rover Mark II / P38
    My last gasp to fix my faulty temp gauge ('02 P38 Thor) is the serial link from the BECM to cluster but I can't seem to find the right plug/wires from the BECM on Rave. Any help would be appreciated. For what it's worth my temp gauge only registers bottom of the blue. I've checked/replaced the...
  7. Range Rover Mark III / L322
    Hello All, I need the RAVE manual so that I can replace my alternator (2003 RR L322). All the links provided on Rangerovers.net appear to be not valid anymore. Some people suggested going to FAQ but I did not have any luck there either. Does anyone have a download link that actually works? Thx
  8. Range Rover Sport / L320
    Hi I replaced the drop link. Now i am getting a warning that i have a suspension fault and it will go down unless i reduce my speed. Do you have to perform a reset or something.
  9. Range Rover Mark II / P38
    Could someone tell me the location of the A?C harness, since my A/C stopped working after replacing fusebox I just want to check it out. The PO said he installed it in the notes but I don't know where that darn thing is. Thx I meant the A/c Compressor Link Harness
  10. Range Rover Mark II / P38
    Hi guys, I've been trying to sort out the vague steering and "crashy" ride on my 1998 P38. I have replaced the anti roll bar bushes and drop links plus the front panhard rod bushes so far. The old ARB bushes were yellow polybushes so I think they were Britpart ones. I seem to have cured 90% of...
  11. Range Rover Mark II / P38
    Hi All, I have a quick question. At some point I bought two tie rods ends part number QFS000010. I was probably making the assumption that there was only one on each side and two of these would replace the worn units. Anyway, I can't remember the logic when I bought these a couple years ago...
  12. Range Rover Mark II / P38
    Hi to all, i know thats is not a new theme, but i read thru older posts and i still, stuck with this problem. I have this P38 diesel, for 6 months, i had some fuel leakage on the fip, send it to repair, put it all back togheter, the engine crancks, but does start ... The diesel does arrive on...
  13. Range Rover Mark II / P38
    Hello all...noticed my Driver's Side Front Sway Bar Link has popped off on the top. The part is as shown below, where the metal end with the white cap is not in place on top but the bottom one is fully intact. This allows the metal "barbell" to swing freely 360* around. My question is, can this...
  14. Range Rover Mark II / P38
    Hi all. I have found shop manuals on eBay for $6 and $5 shipping from the UK but I assume they are for RHD trucks. Any link for a LHD 02 P38 US version? Is the brand RAVE! Is RAVE an acronym? Or is RAVE the author? Please clarify. Thanks ColoradoCrow
  15. Range Rover Sport / L320
    I broke one over the weekend. When I try and back the nut off, the entire thing spins. Is there a way to stop it from moving while I back the nut off? Thanks fellas.
  16. Range Rover Mark II / P38
    Trying to figure out if the ball joint that connects to the pitman arm on the drag link is the same as the ends of the tie rod.I don't need to get the whole assembly to replace one worn part. My local part store has the tie rod ends...Or, is there compatable part from a different vehicle? My...
  17. Range Rover Classic
    Hello my driver side door lock has broken so I have to lock with the passenger door. I cant seem to be able to find the cam link for a 1994 classic does anyone know where to get one? The key barrel rotates the cam link to lock or unlock its made out of plastic I cant believe it lasted this long.
  18. Range Rover Sport / L320
    I was wondering if anyone can tell me the following. I just installed the factory trailer link kit for my 2013 supercharged sport. Is there any programming required so the vehicle will recognize the new harness?
1-18 of 55 Results