RangeRovers.net Forum banner

joints

  1. L322 2003-2005+ Front Ball Joints Comparison/Review [VIDEO]

    Range Rover Mark III / L322
    Hi all, I recently went through an ordeal with ball joints on both of my rovers and have tested several manufacturers' offerings so I made a video describing my experiences with them. Just wanted to share and hope it helps you all out. BTW, by the end of the video I got the terminology for...
  2. Which size boots for our ball joints?

    Range Rover Mark II / P38
    Boots are disintegrated off the ball joints, but ball joints are still very tight. Want to just replace the boots packed with fresh grease. Can anyone indicate what size the boots are? https://polyboots.com/tie-rod-end-and-ball-joint-boot-14x31x23-mm-black-type-1
  3. Beware cheap U joints.

    Range Rover Mark II / P38
    I recently had to do an urgent replacement of the front most U joint on the Borrego. It was gone and just short of catastrophic failure. It started vibrating very suddenly while I was a long way from help, so nursed it home.... I searched in vain at all the local auto parts for quality U...
  4. DIY: Front Upper/Lower Ball Joints

    Range Rover Sport / L320
    Here’s a how-to guide on doing ball joints. Sorry I don’t have any pics. I hate grabbing my phone with greasy hands. I’ll do my best to describe. I had issues were the clicking/popping sound, imprecise steering feel, and slight wobble at high speed. My ball joints were worn out, even though...
  5. Steering wheel play - Tighten set screw? Ball Joints

    Range Rover Mark III / L322
    Hi all, I'm having some play in my steering wheel, at all speeds. When the vehicle is parked, I could easily turn the steering wheel back and force for about half an inch on each side without feeling any resistance. Surely the front wheels do not move. At low speeds the play is still there but...
  6. LOUD creaking OSF steering / suspension

    Range Rover Mark III / L322
    Hi all. My 57 plate Range Rover vogue TDV8 recently developed a VERY loud creaking noise from the front right off side. It happens below 5mph and only on the last 3/4 of full lock when turning right. Steering back to the left creates no noise. Had the PAS fluid replaced and no improvement...
  7. front ball joints.

    Range Rover Mark II / P38
    ok so i,ve got to bite the bullet and replace my front ball joints.i have read a fair bit of info about this but i,m not too sure about replacing the oil seals.Some say you need to centralize the oil seal with a tool others say it will be ok if you dont move the adjuster nut.Living in Spain i...
  8. top and bottom ball joints.

    Range Rover Mark II / P38
    Hi i live in spain and because of the heat all four of my ball joint rubbers have perished.i have tested the joints and they have no play in them.To replace all four joints is a massive job just because the rubbers have gone.Has anyone any bright ideas to say me time and money,mainly time and...
  9. Ball Joints, tie rods etc.

    Range Rover Mark II / P38
    Hey Guys, I need to replace a couple tie rods and ball joints on my rover, this will be the second replaced set and I'm sick of not having grease-able joints, is there any way I can get moog parts or some high quality tie rod end and ball joints with grease fittings? thanks guys
  10. Changed & Greased U Joints - New Grinding Noise at Low Speeds?

    Range Rover Mark II / P38
    Changed & Greased U Joints - New Grinding Noise at Low Speeds? Hi All, First, just want to say thanks to everyone up here. I've been lurking for a couple of years and always knew I would be getting a P38. I recently pulled the trigger, and I avoided a lot of problems with other P38s thanks to...
  11. front axle ball joints

    Range Rover Mark II / P38
    I bought a second hand axle today after snapping mine and one side was fitted with ball joints that have grease nippals and this has got to be the best uprated p38 mod yet now my question does anyone know where i can buy them from to replace the uther site i have spent most of the day looking...
  12. Range Rover Vogue 2007 brake pipes and top hub joints

    Range Rover Mark III / L322
    Hi im new to this forum. I have just had my car serviced and have been told that the brake pipes need replacing due to age and should be done every 6 years. Is this true? Also im being told there is play in top hub joints. What does this mean and how important is it that this done? Is it an...
  13. Drive shaft and ball joints

    Range Rover Mark II / P38
    So I recently bought a p38 for 1000$ little rough but I don't mind. I have owned a discovery I and a lr3 so I'm pretty familiar with these. Truck has 175k on it and I doubt the drive shaft has ever been maintained. Are these serviceable or do you have to replace the whole thing? It currently...
  14. Repair costs of new ball joints!

    New Member Introductions
    Anybody be able to give me a rough price on price of new ball joint for rrsc 2005 model! Jamierm79
  15. 2006 RRS HSE - Replacing/Repairing LCA, Bushing, Ball Joints - Need your Opinion!!

    Range Rover Sport / L320
    2006 RRS HSE - Replacing/Repairing LCA, Bushing, Ball Joints - Need your Opinion!! So, my 2006 RRS has been making the "clunking" sound from the front, and I have received two quotes to get the lower control arms, bushings and ball joints replaced - one from the local LR dealer, one from a...
Top