Search Results for ‘installing’

Old matrix spewed coolant inside so had to replace. Managed to removed dash and replace the matrix. All went back together and no leaks. Only problem is certain electrical equipment is now not working. Interior lighting Puddle lights on doors Bonet (hood) inside light Power mirrors heater...

There are quite a few transmission related posts here already. If this is a repeat I apologize. I did a search and couldn’t find a similar problem. While reading, it does seem that a few of you are transmission “go-to” guys so I hope you can help. We have a 2006 Rang Rover, great truck for many...

Hi All I am about to wire in aftermarket water temperature and oil pressure gauges. I've been trying to find a walk-through or an article showing where to splice for the instrument lights. Is it as simple as a splice from the output lead at the dimmer switch? Any better way to do it...

Hello, forum Just curious how straight forward is it to install a new foglight assembly on a 2010. It is the passenger side. Has all the plug connectors and screw mounts. What tools are needed? Anything special? Best, Ashtray

I'm thinking of installing a remote start on my RRsport. did anybody have this done on their car ? Dealer don't wanna do due to lots of electrical issue.

Hi, I own a 4.6 HSE from 1996, or 97, the previous owner converted it to coil springs, and neglected it quite a bit. Next pay I have planned to buy everything I need to put it back on air bags. I did do a bit of research, but I just want to make sure I didn't overlook something.. Airbags and...

Does anyone know if there are instructions to mounting a OE front brushguard to a 91 RRC? I understand the mounting points, but wondered if there were instructions on how much and what amount to cut off the plastic front spoiler to allow access to mounting location? My truck did not have one on...

I reset my Vanos timing today, installed the jigs andtightened inner torx and timing wheel nut to spec. Unlocked the engine and slowly turned…itappeared I had slack in the chain and I was concerned it may have jumped atooth but moved it back in the other direction and if it jumped the in...

Anyone installed towing hitch after delivery? Is OEM only option for 2017 RR SC L?

Installing roof bars....question about the "tabs" on roof So I just purchased these OEM style roof bars for my truck. On top of the roof, there are 3 little "tabs" on each side. Do I have to snip these off with pliers or do they somehow come off easier? I saw an instructional YouTube video...

Once the tranny was removed, I then unbolted the Torque Converter from the fly and had it rebuilt. Prices ranged greatly, from $125 to $425. My question regards reassemblage and is rooted in someone telling me that I shouldn't assemble using the reverse procedure as I might somehow damage...

So I have a 2010 RRS S/C and I decided to fit it with the 275/45 20 Cooper Zeon LTZs because I had them on my fullsize RR and loved them. However today when I went by the shop they informed me that there is a severe vibration at anything past 45mph after installing these new tires. There was...

Hi Everyone, Curious if anyone here has installed a Clek Foonf rear-facing car seat in their back seats? We have twins, so we will be buying and installing two of them. My fear is that once these seats are installed rear-facing, both driver and passenger front seats will have to be moved up...

I am in the midst of trying to solve a rough idle/poor fuel mileage issue on my '93 LWB. Before I start throwing new parts at it, I want to take a look at what the ECU sensor data looks like using the Rover Gauge. I have the serial cable ready to go, but I cannot figure out how to compile the...

Hey guys, I started to install the oem roof rack for my sport and got one side done. However while trying to remove the three plastic plugs on the other side, they all broke off at the top leaving the body embedded in the hole. I tried using a set screw extractor bits but will never be able to...

Has anyone done it? Please post pics. I a, trying to decide the cleanest way to install.. not many options. Has anyone removed the factory CD changer? Waste of space.. can one buy a delete box?

The Friday before last my 98 4.0 SE sputtered, coughed and crawled home to die in my driveway. Checking for fuel pressure at the rail gave zero. The relay clicks and the pump sounds like it is running so after reviewing past posts here I ordered an Airtex E3270 from Amazon for $58. I am hoping...

hi all, i am newbie to all this, i have bought myself range rover vogue 2010. recently i change the whole interior from a Autobiography to mine, which had rear dvd screens and hot and cold seats, i also fitted the dvd player and rear entertainment unit in the back and wired everything up, it all...