RangeRovers.net Forum banner

inlet

  1. RRC 88 inlet manifold

    Range Rover Classic
    Hello, i have a RRC 88 with stromberg CD175 double carbs, there is a hose connection from the radiator to the inlet manifold block, what is that for? and on the inlet manifold block side the hose is closed because of rust, shall i remove the rust to let the water go inside the manifold?
  2. Air inlet temperature sensor delay ?

    Range Rover Mark II / P38
    On checking the Nanocom display with the vehicle cold I'm getting a -5* C reading with an outside temp of around 8*C. Take the car for a drive until it's warm (temp needle in the middle) and the Nanocom then shows the same temp as the external temperature 8*C. Is there a warm up delay for the...
  3. Valley Pan Gasket (Inlet Manifold Gasket) Replace Query

    Range Rover Mark II / P38
    All: I have a coolant leak at back of engine which ends up dripping off the bell housing. I'm thinking that its a leaky Valley pan gasket. Have done a fair amount of research and thoroughly read the RAVE manual. Looks like most of the top end has to come off, which will be a first for me...
  4. EAS inlet and exhaust filters

    Range Rover Mark II / P38
    Hello all, After looking at my spare valve block (pondering servicing the block just for experience/backup) and unscrewed the exhaust filter has anyone ever refurbished this and the inlet filter? Am I right in assuming that these filters can be screwed off without any depressurisation...
  5. Oil Filter Inlet hose...? '03 HSE

    Range Rover Mark III / L322
    Hi there guys- I have recently had a severe oil leak and upon my mechanic's inspection, discovered the oil filter "inlet" hose (part #LPQ000030) has a rupture and needs replacing. My question is this; do any of you know if the BMW E39 "engine pressure hose" (pt#11421440181 for those who know...
  6. Skimmed Heads + Skimmed Inlet = Misaligned Valley Gasket

    Range Rover Mark II / P38
    Hey everyone, I have been having a complete nightmare with the rebuild of the top end of my GEMS 4.6!!!! Firstly I have to make it absolutely clear that I am no mechanic in anyway shape or form. So please do not insult my seemingly useless mechanical knowledge!! But me being me I decided to...
  7. Upper Inlet Manifold Tightening Thor

    Range Rover Mark II / P38
    Does anybody know the tightening sequence and torque setting for the upper inlet manifold bolts on a Bosch THOR engine?
  8. Inlet Manifold Outlet

    Range Rover Mark II / P38
    2000 RR 4.0 SE What's the purpose of the outlet on the inlet manifold just behind the throttle body flange next to the TPS? (see upper left corner of attached pic) A vacuum line runs from the outlet to the air pump solenoid valve. Should I clean the outlet occasionally with carb cleaner...
  9. Inlet manifold vacuum barb

    Range Rover Mark II / P38
    This morning, when putting a hose clamp on this part, the barb snapped off. It seemed very brittle. I urgently need to replace this today as I have a full day trip tomorrow at an adventure park. Does anyone know what the thread format and size is on the part still stuck in the manidfold? If...
  10. Callaway help please - Inlet Gasket

    Range Rover Mark II / P38
    Had the new ride in for issues with the throttle position sensor and now that is straight. Issue now is a leak of coolant from the intake gasket. I did not realise that the Callaway had a different gasket, but they do. It has a part number of LRN7306CAL and is completely missing from the Earth...
Top