RangeRovers.net Forum banner

injector

  1. Thoughts on deleting fuel injector plug retaining clips?

    Range Rover Mark III / L322
    Hi guys I’m finishing up a timing job on my 05 Range Rover with 4.4 m62 engine. As the title says, I’m leaning towards deleting the injector plug metal retaining clips to make future removal easier. Those things are such a pain in the butt to remove with a pick tool. I figure since the injector...
  2. Fuel Injector connector fix (1992 Classic 3.9L)

    Range Rover Classic
    Thank you to everyone for all the great posts. This is my first (set of two) posts to offer a solution to a couple things I wasn't able to find. I replaced a fuel injector connector in my 1992 Classic (3.9L) with a generic Napa part. Between the computer and your fuel injectors, there are...
  3. Fuel Injector Removal Tool

    Range Rover Sport / L320
    Looking for store to purchase this tool in the USA, anywhere between Ohio & Tennessee. Please let me know if there are any local shops that sell these tools. Fit 2010 RR Sport 5.0 SC Thanks!
  4. 2.5dse injector pipes

    Range Rover Mark II / P38
    Guys one of my high pressure pipes from my injector pump to the injector has split and I need a new one, I was thinking of geting a set of six. Where can I get them from Thanks K Sent from my GT-N8010 using Tapatalk
  5. No Injector Pulse Resolved!

    Range Rover Classic
    Alright, what with the frustrating problems I've been having with my 1991, I've finally figured them out. Started with an occasional crank but no start, but would start with a shot of ether. Replaced relays with new old stock Bosch 0 332 014 112 after noting they did not click occasionally. Use...
  6. Bosh Injector o-ring install tools

    Range Rover Mark III / L322
    I was watching the Atlantic British video below regarding removing and installing injectors for a 5.0. I have the tool that removes and installs the injectors. About half way through the video the Tech uses two small tools that install the bottom seal ring and then sizes it. Does anyone know...
  7. Injector copper washers 2.5 dse

    Range Rover Mark II / P38
    Guys Where's the best place to get the copper washers for the injector s from and the leak off pipe Thamks Sent from my GT-N8010 using Tapatalk
  8. 03 RR diode located within left injector wire loom cover

    Range Rover Mark III / L322
    Hello, all. The Body Control Unit functions of my 2003 FFRR has been acting up for a while now, and I've been checking ground points and connections where I can, with no luck. The problems have been things like various buses not working, the doors not always automatically locking at xx MPH, odd...
  9. BMW M51 2.5 injector seat

    Range Rover Mark II / P38
    Hi folks, I have a P38 with the BMW M51 lump. I bought it with an overheat issue which (long story short) turnned out to be no less than 3 cracks in the head. Bought a recon head off the ebay, fitted it and annoyingly it is chuffing fumes passed injector 5. I had anealed the seals, so...
  10. Fuel Injector Removal

    Range Rover Sport / L320
    2006 RRS Supercharged....97000 miles. I want to have the fuel injectors removed and cleaned ultrasonically as I am getting P0307 and P0306 misfires. The spark plugs have been changed and I still get the cords. My Indy shop does the work and they are usually pretty good about the pricing...
  11. Diesel fuel injector pump (FIP) when do they wear out?

    Range Rover Mark II / P38
    Hi I have a couple of P38 diesels and I suspect one of them might be developing a fuel pump issue. Reading codes I get code 136, fuel actuator circuit fault. Also once in perhaps 10 times you dip the accelerator at idle it will almost run away (1600-1800 RPM) and then almost stall (500-600) for...
  12. Fuel Injector replacement

    Range Rover Mark III / L322
    I'm replacing the #2 fuel injector in a '11 RR HSE. As seated in the driver's seat, what is the location of the #2 cylinder on the engine? Thank you!
  13. Fuel Injector Rubber Boots?

    Range Rover Classic
    Hi All, I've looked all over for these... The rubber boots on my injectors are old and cracked. Does anybody know where you can get these? Thanks.
  14. P0303 Solved, Fuel Injector Replaced, but....

    Range Rover Mark II / P38
    My 1997 P38 4.6L was throwing the "usual" collection of codes which I pulled up with my Nanocom: P0303, P0300, P1313. I first replaced the spark plugs, ignition wires (8mm) and the coil for cylinders 2 & 3, and kept getting the same codes after resetting the MIL. I finally diagnosed it to a...
  15. Injector Circuit/Open - Cylinder 4 (Code P0204)

    Range Rover Mark III / L322
    2007 RR HSE (Non-Supercharged; 60K miles): Engine recently started missing/running rough. Ran codes and found: P0171 (System Too Lean - Bank 1) P0174 (System Too Lean - Bank 2) P0442 (Evaporative Emission System Leak Detected - small leak) P0204 (Injector Circuit/Open - Cylinder 4) *I've had...
  16. Suspect injector seals, starting issues

    Range Rover Mark II / P38
    Hi guys, I've been having starting issues with my p38.. When it's left overnight it turns over for a while before it starts, I've replaced the sender unit & pump, also put a none return valve just before the filter, replaced the leak off pipes.. However, I've just pulled the leak off pipe on...
  17. INJECTOR PUMP APPEARS FAULT - P38 NO START IF ENGINE IS HOT

    Range Rover Mark II / P38
    Is there anyone who has experience with the injector pump for P38 2000 Model, 2.5 BMW Disiel engine?. Their help will be grately appreciated. The pump is a Bosch fitted to 2000, 2.5 BMW engine. The Problem with the vehicle is it cranks forever before it eventually and if the engine is hot it may...
  18. No Injector Pulse

    Range Rover Classic
    Ok folks. I really hope I can get some help here. I have a 95 Classic, and I pulled the engine, reinstalled everything, and now I can not get an injector pulse. I hooked up a noid light not cylinder 1 harness, and it does not light up. I am using an MSD box that worked fine prior to the...
  19. Forgot fuel injector clips (Doh!)

    Range Rover Mark II / P38
    My weekend was spent tearing down my Bosch 4.6 and replacing a leaky head gasket. All said, I think things went pretty well (sheared valve cover bolt notwithstanding). However, this morning while I was describing to my wife the problems I ran into last night getting things back together, I...
  20. EGR & Injector No4 sensor issues

    Range Rover Mark II / P38
    Hi I have a P38 2.5 DSE (BMW Engine) 1994, Manual. Here in Portugal sent the car to the local (Southern Portugal) garage (as i didnt have time) for new leak off pipes, fuel lines, glow plugs, filter etc. On return engine check light was on and i had a very fast (1500rpm) tickover when hot, i...
Top