hydraulic

To anyone that this has happened to . 2013 Range Rover Sport - Both sides of my rear tailgate lifts are popping off on the body side where they attach to the round ball socket. It appears that the ball on the body mount is worn. Do I need to replace both the hydraulic lifts and the mounts or...

OK, I need some expert advice before I attempt to start tearing stuff apart and this is the place to look. To start I have a 2006 RR HSE LUX w/4.4 AJV8 and 112750 miles on the clock. I have poured over many threads trying to narrow down the engine noise I have. After watching countless videos...

Whenever I start my 1990 classic up I notice the electric hydraulic pump runs for around 20-30 seconds to build up pressure before the red brake warning light goes out. The truck will exhibit this behavior any time it sits for more than about an hour. I also notice the pump kicks on after 2-3...

I've been monitoring/logging gearbox behaviour these past few days using the live values logging and then analysing on on an Excel worksheet. The tools logs a lot of valuable information that has allowed me to check that there is no slip in each gear, the TC clutch seems to be working fine and...

the compressor/pump for my hydraulic system is dead. i have to replace this item. the productcode for the compressor is RQG500090 i have found an used compressor with this code RQG500060, will this fit? my model is a l320 supercharged 2007 the item that i found comes from a Range Rover Sport...

Hello, am new to the thread but have a question about my range rover sport. I saw the light come on the dash one week ago for suspension roll over fault (arrow to the right and left above the vehicle). I took it to a local shop and was told my hydraulic fluid was leaking. It would be...

I have a 10,500lb Milemarker Hydraulic winch that runs off the steering box in my 89 Rangie. --My Rover needs a new engine, and I have the option of trading the winch to a local Unimog guy for a good 70k mile 4.0 long block with transmission. So I'm considering going for the trade, and have a...

80,000 miles ago, I overhauled my 3.9 litre RRover, but knowing next to nothing about the hydraulic valve lifters, I did nothing to them, thinking that little could be done to them, since they hydraulically are self adjusting---WRONG, they are noisy, tap, tap, tap! I think that I heard...

Hi have just joined your Forum and there is some great info here and i am enjoying belonging to my first ever forum. I have been reading up on the replacing the Hydraulic bushes in suspension arms with urethane bushes and was wondering if anyone has used these and if there is a difference in...