Hello everybody, I searched in the manual, but I did not find: Can anybody tell me how to switch off the touchscreen ? My wife like this to be dark when driving in the night ;-) .. Harry

Hi I'm doing work on my 2000my 4.0l V8 and before i start I'd like to do a compression test. Never done this on a computerised vehicle before, so wondered if i need to do anything special? Normally, I'd pull all the plugs, disconnect to LT lead to the coil then screw in the tester and turn the...

Did a search and didn't see one, so here's a quick tip for people who don't know! Step 1: Press upward on the sunroof toggle switch for around 30-40 seconds or until you hear a slight click/bump Step 2: Test it, yeah, it really was that simple :lol: My dealer told me this when I brought my 05'...

Hi all, this weekend I was doing some work on my dads L322 and was looking for some info on changing the rear brake mud shield/guard. Because of its ridiculous design you have to remove the hub/assembly and would probably end up changing the wheel bearing at the same time. I noticed Atlantic...

The purpose of this write-up is to provide a ‘how to’ for replacing your thermostat assembly should the same thing occur to your RRS as mine did – as seen here; http://www.rangerovers.net/forum/9-range-rover-sport-l320/81761-2006-sport-overheated-reduced-engine-performance.html. Depending on...

So not too long ago Is started noticing the fabric on my A-Pillars was coming off on my 2006 RRS HSE. It looks awful if left alone, so it's one of those cosmetic things that needs fixing. I asked how to do this a few days ago, and was directed to...

HEVAC Book Symbol (Revisited for the Nth time) and Flap motor swap HOWTO So I've had the dreaded book symbol for a while along with ambient air only on the passenger side (LH Drive vehicle) and low airflow generally.The wife stated in not so many terms that even just a short trail ride was out...

Fuel door stuck open. How-to link broken, tested switch and actuator... I pulled the switch on the dash and checked with a multimeter. I'm seeing a open circuit until I press the button down. I disconnected the harness from the actuator and I see 12 volts all the time at that connection. I...