Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

21-38 of 50 Results
  1. Range Rover Mark II / P38
    Is there anyone out there doing a silicon hose kit for the P38 V8? There are plenty for defenders, discos and the diesel P38 but I haven't found one for mine.
  2. Range Rover Mark II / P38
    I need to replace my oil cooler and hoses from our 2001 4.6HSE. Altogether they are a pricey lot but I see in UK I can get an oil cooler and hoses from a DSE for less than half the cost, conversion rate and shipping considered. I am unable to find any information as to whether or not the DSE...
  3. Range Rover Mark III / L322
    Hi, I am new here so I may not know well how to post this but here is my "problem" : I have a 2007 RR L322 Supercharged and my 2 hoses from the Aux Oil Cooler are not attached to anything and the lower one looks ripped but I can't find the other "side" supposedly where it ripped from so I have...
  4. Range Rover Sport / L320
    Hi RRS fans ;-) I have bought the rebuild kit for my air compressor. But I don't know how to disconnect the 2 air lines / hoses ( red circle in the picture ) Already pulled like crazy but it doesn't move ... Thanks in advance !!
  5. Range Rover Mark II / P38
    On my 2001 4.6 HSE I have a small (to sometimes medium) coolant leak through 1, 2 or possibly 3 small hoses (just not sure which one is leaking, or if they all are) on the top of the engine, just below and behind the accelerator wire (see pic below) You can see the corrosion and build up...
  6. Range Rover Mark III / L322
    What are the two curled over plastic hoses in back of manifold. looks like they are both coming from the transmission right and left. does the passenger side one go to the back of pcv valve. there is an open port. Also what is the plastic elbow hose by the transmission its cracked and looks...
  7. Range Rover Mark II / P38
    Just putting my engine back together and have no idea where the hoses go to. It iS the EGR model. There is a pipe running under the inlet manifold which had no hose on it and there is a small valve on the passenger bulkhead that looks like it needs something going to it. Also there is a hose...
  8. Range Rover Classic
    Do the power steering hoses use o rings where they connect to the steering gear box? Mine are all tight, but still leaking slightly where they screw into the gearbox.
  9. Range Rover Mark III / L322
    I have a 2008 RR with 75,000 miles. What's the consensus on the factory recommendation of replacing brake hoses after six years? Why should brake hoses go bad in six years? I've never heard of that before with older cars. Anyway, what's everyone's views on it. Thanks.
  10. Range Rover Mark II / P38
    water leak I had a leak on one of the hoses so took it off replaced clip and refitted I refilled with water no water leaked out so started engine no problems drove home 6 miles heard bubbling from header tank removed cap water came out so let it cool down for 1 hr then topped up ran again for...
  11. Range Rover Mark III / L322
    Do the air hoses from the compressor run through the rear bumper at all?
  12. Range Rover Mark II / P38
    I am switching out thermostats, and like an idiot, I did not mark the two smaller hoses ontop of the thermostat when I took them off and now they are mixed up. Where does the center small hose lead to..... To The reservoir or off to the motor? Does the hose off of the overflow tank go to the...
  13. Range Rover Mark III / L322
    Hey Guys, I've been working on trying to fix my cooling system and noticed I'm missing two hoses. I just bought the Transmission Cooler and the two Transmission Cooler Lines as shown in the diagram below. The problem is, I need to find the oher two hoses that go into the other side of the...
  14. Range Rover Mark II / P38
    Rather than buy preshaped coolant T hoses (radiator hose), has anyone successfully created their own using a metal T piece and some spare hosing. I'm thinking of trying to create a radiator top hose. I see that some of the hoses for sale have this set up, rather than being one complete molded...
  15. Range Rover Mark II / P38
    Hi, It was time for new rotors, pads, and brake flush on my 2000 P38, so I decided to go ahead and replace the brake hoses with the stainless replacements available from Atlantic British for the purposes of longevity, and also hoping for better pedal feel. Just jumped into the project...
  16. Range Rover Mark III / L322
    Anyone know what size the transmission cooler hoses/lines are on a BMW RR? Thanks.
  17. New Member Introductions, No Questions Please
    Joined this form recently and Looking forward to participate in various discussion Hi, I have joined recently. I am dealing with various automotive industrial people. We make fuel, air and oil hoses, mainly thermoplastic type. I look forward to take parts - give and take basis- regularly. Maniar
  18. Range Rover Mark III / L322
    Just completed inspection of PCV valve and associated hoses on 05 L322 4.4L V8 and have a few questions: 1) I have rubber blanks fitted to both of the hose fittings on the top left and right of the PCV valve body (large red and yellow arrows on pic below). I have seen at least 1 vacuum hose...
21-38 of 50 Results
Top