RangeRovers.net Forum banner

holes

  1. Drain holes in air plenum?

    Range Rover Mark II / P38
    I am heading into my P38 fresh air intake plenum at the base of the windscrean this weekend to replace the filter but moslty to try and fix the source of water running into both side of my foot wells. The plenum filter is goone and it looks like there is a lot of pine needles in there. I am...
  2. Best method to put front license plate without holes

    Range Rover Mark IV / L405
    Got a citation to put front license plate yet don't want to drill holes on the front bumper. Any ideas and recommendations will be appreciated !!
  3. 4 holes in the rear part of the headlining CAN/AUS vehicles?

    Range Rover Mark II / P38
    Hi! A friend of mine bougt the Canada / Australia version of the headlining since it was the only one available from Land Rover Germany and when it arrived he noticed 4 holes, just above the tailgate. Does anyone have a clue (or even picture) what these are good for? Cheers Carsten
  4. Holes drilled in heater assembly?

    Range Rover Classic
    I'm rebuilding a heater assembly - new blower motor and heater core. This particular housing someone (I think) drilled a couple holes in it. Any ideas as to why, and should I fill them before reinstalling the entire assembly? Sent from AutoGuide.com Free App
  5. Holes under rear side moulding strip? '95 NAS LWB

    Range Rover Classic
    Hi guys, I've removed the black rubber door stripping across the sides of my '95 LWB and spotted a set of holes underneath the rear-most strip. Looks like mounting points for a rear side repeater or something, also sure I spotted some cut wiring behind the panel. Seems odd to me — both the...
  6. Drill HOLES into A/C mixer gates to open and access cold air possible?

    Range Rover Mark II / P38
    Drill HOLES into A/C mixer gates to open and access cold air possible? My 1998 P38 HSE has been into service 4 times and over $4500 for A/C ///Heater problems. Thanks to this forum, I now know the mixer gates are not working properly- nothing happens when I select the various vent locations...
  7. I have removed my LR roof bars, now got four holes

    Range Rover Mark III / L322
    Hi, I have just removed the LR roof rail bars from car, they came with car when I bought it. as it came with no keys I have unscrewed the star screws and lifted off in one complete unit. Now that the it's off there are holes in the roof, I take it there should be plastic plugs of some kind in...
  8. Can 'powered' running boards be removed and not leave holes or finish issues???

    Range Rover Mark III / L322
    Can 'powered' running boards be removed and not leave holes or finish issues??? If an 08' came with power running boards can they be removed without damaging the finish or leaving holes or witness marks that they were there before? Any cockpit or cabin switch holes? Thanx!
  9. Suggestion? How to mount floor boards with missing pre-drilled front holes

    General Chatter
    Suggestion? How to mount floor boards with missing pre-drilled front holes So, I know I could post this on the MKIII part of the forum, but this more of a general question as it has to do with joining, bolting, connecting or something metal to metal. I picked up some OEM floor boards for my...
  10. Spare doors with bullet holes anybody?

    Range Rover Mark II / P38
    We have been to look at a P38 today, looks a bit odd but is being used in a film shoot. They tell us it will be sold on afterwards complete with the spare doors and bonnet that have bullet holes in them! anybody want a different look???
Top