RangeRovers.net Forum banner

hole

  1. Threaded hole in tranny case.

    Range Rover Classic
    Hello Everyone, I recently purchased my first Range Rover Classic 89'. I love the truck but like most, it has its issues. I just went underneath it for the first time today and found this. There is a threaded hole into the tranny, as if there is meant to be some sort of bolt or plug. I have...
  2. Dealer drilled extra hole for rear plate

    Range Rover Sport II / L494
    Hi everyone, I finally took the plunge and bought a CPO 2016 Range Rover Sport and have been loving it so far. After I brought the vehicle home a couple days ago, I noticed that after the dealer had installed my new rear plate, the holder was crooked. I removed it to remount properly, and...
  3. Engine Long Block Hole - Boston,MA USA

    Range Rover Sport / L320
    I own a 2006 Range Rover Sport HSE with 101K miles, excellent condition, well-taken care, garaged and has seen very few winter roads, all maintance did per OEM recommendation & schedule. Background:I moved to city 2 years ago, my RRS HSE has been driven less than 500 miles the past two years...
  4. Greetings from Jackson Hole, Wyoming

    New Member Introductions
    I have a 2012 Range Rover HSE which I purchased two years ago. Prior to that I had a 2011 Sport. Greatly enjoy driving this car and looking forward to being a member of the network. Best, Pierce
  5. Lost key - scored a hole in one

    Range Rover Mark IV / L405
    So I dropped my key and it went under the passenger seat and into an opening which I couldn't reach. It then made a clink clink noise and fell ever deeper when I was driving. Needless to say - can't reach it. Can anyone give me a tip how to remove the plastic rail cover I picture 3 so I don't...
  6. Pot hole "fixed" tailight issue! Now what.

    Range Rover Mark II / P38
    I've had this issue with the left side tailight self extinguishing after a two or three miles of driving for a couple of years now. Only happens when driving, will stay on as long as I care to let the battery run down if stationary, and none of the usual fault finding methods have worked. Took...
  7. Clarification on the inspect hole for engine main seal leak.

    Range Rover Mark II / P38
    Afternoon, Can someone confirm for me that the slot you look through in order to see if you have a rear seal leak is the circular one that is in the front of the transmission bell housing with three bolts holding it in place? Am I correct, that you just remove that to have a look and if there...
  8. Jackson Hole Roadtrip

    Range Rover Sport II / L494
    Hey all, so I decided spur of the moment to head up to Jackson Hole with my RRS Supercharged. Was a crazy drive through several blizzards and some epic scenery but made it! Took a few photos along the way.
  9. Cubby hole measurements?? By the clock

    Range Rover Mark II / P38
    Hi guy,s.. Can anyone give me the cubbyhole measurements ?. I've taken this image from another forum & I'm more interested in the depth of this (I'm sure that there must be a double din which is shallow enough to fit) Thanks in advance Ash
  10. 03 L322 Tailgate Cable Bolt Hole Stripped Out on Tailgate

    Range Rover Mark III / L322
    Hello, I noticed my passenger side tailgate cable dangling and I simply tried to screw it back in but nah, no threads to screw into where the end of the tailgate cable would. I checked the driver side, unscrewed the bolt and there are sure enough some threads to screw into. What's the deal...
  11. Roof rack mounting hole measurements: anyone have them handy?

    Range Rover Sport / L320
    Roof rack mounting hole measurements: anyone have them handy? Hi All, I am just wondering if anyone has the spacing measurements for our roof rack mounting holes. I am working on a custom rack (any the truck is away right now so I cant measure). If anyone has them handy or can point me to a...
  12. Hole at the topside of Catalytic Converter - Air leak in Bank 2

    Range Rover Mark III / L322
    Hole at the topside of Catalytic Converter - Air leak in Bank 2 Shop told me today that I have a hole in my drivers side Catalytic converter. They gave me two options to repair. Either take the Cat down and weld it or place a clamp on it to seal it. I believe places a clamp on it is a little...
  13. Spark plug hole size - m14x1.25?

    Range Rover Mark II / P38
    Have a terribly fitting plug on No 1 cylinder than appears to be stripped. Look at repairing with Time Sert but I cant seem to find the right plug hole size. Is it 14x1.25?
  14. I don't think this hole is supposed to be open? Need help identifying...a cap/plug?

    Range Rover Mark II / P38
    I don't think this hole is supposed to be open? Need help identifying...a cap/plug? Decided to hold on ordering gaskets until I knew it was the gaskets. Got under the car and cleaned it up and tightened the pan to 17lbs...Hoping that will help with the leaks. Many bolts were not tight. While...
  15. Mid Speaker hole spacing, MY99

    Range Rover Mark II / P38
    Hi, I know the mid speaker is a 63mm (2.5") job, but I am hoping somene has one they can measure for me, I need the exact size and hole spacing since I am trying to find a drop in replacement. The two best options seem to be this...
  16. Fire in the Hole

    Range Rover Mark II / P38
    Shortly after starting the S.O.B., smoke started seeping out of the headliner (driver's side). I thought this was the end of the road for my rig, but she didn't burn (thank God). I just finished removing the headliner and found several wires melted together. Said wires lead to the driver's side...
  17. HELP! The Mud Hole was Bigger than I thought!

    Range Rover Mark II / P38
    Greetings. I'm new to the RangeRover.net Forums & I've got a situation that I need fellow Rangers advice. - I have a 1998 P38 RR & this past weekend hit a Mud hole that was too deep & stopped me dead in my tracks. It went in favoring the left side & once hit the engine stopped almost...
  18. leaking powersteering and water coming out of a bolt hole from waterpump housing

    Range Rover Classic
    leaking powersteering and water coming out of a bolt hole from waterpump housing the underside of my RRC looks like the tar sands in alaska, and that's because of the pump of the powersteering is leaking like nothing else, but i can't see from where, because everthing is coverd with a thick...
  19. Water pump install...stripped hole

    Range Rover Mark II / P38
    I somehow stripped one of the short bolt holes when installing my water pump. I'm guessing I have to helicoil it. I have inserts that fit the water pump bolts. Is that the right size? Any suggestions or advice?
  20. Hole Sizes

    Range Rover Mark II / P38
    Hiya Can someone tell me the thread size/type for the inlet manifold into the block please. (12 bolts) I want to use a tap to clean the threads out before refitting. Many thanks Simon.
Top