RangeRovers.net Forum banner

heights

  1. Suspension heights - calibration needed?

    Range Rover Sport II / L494
    Can anyone with a 2014 RRS on 21" wheels possibly do me a favour? Can someone measure wheel centre to arch, vertically, front and rear? For Access height, Normal height and Off-road height? I have a feeling my car is out of whack and needs a recalibration but I'd like to have some numbers to...
  2. Need advice on my p38 EAS issue with programmed heights

    Range Rover Mark II / P38
    Proud owner of another old Rover, My own exhaustive searching on the site has not yielded an answer other than EAS was designed by sadists. I'm fairly certain that I have a slow leak somewhere because when I do have an issue where the light on the EAS shows it in access/crawl, I'll leaver the...
  3. Gen III's installed - how about some new ride heights?

    Range Rover Mark II / P38
    Finished! Took care to grind off any errant welds in the rear spring perches and paint over the bare metal. Very very happy with the way things thing handles. Now I want to reprogram in some new ride profiles. While testing and pressurizing the system I kept going up on the individual springs...
  4. RSW software version 2 - 'heights' tab an

    Range Rover Mark II / P38
    My search skills are rubbish i know,,,,, uk 4.6 eas compressor running continously pretty much - piston seal cream crackered replaced still keen to run way too long swapped for known good compressor - sorted but then an eas fault cropped up - hadn;t had to use my RSW software for years (also...
  5. Recalibrating Ride Heights

    Range Rover Classic
    Have working air suspension in my 1994 Classic LWB. Lots of parts and work but worth it. My remaining problem is recalibrating Low height. Standard and High recalibrate just fine. Low is not responding to changes in input values. Is there a relay in the low circuit that might be bad...
  6. Standard Heights

    Range Rover Sport / L320
    What are the standard height (air suspension) for the 2013 RRS? Would that be for the normal mode, and measured from where to where? Thanks, Gerd
  7. suspension heights

    Range Rover Mark II / P38
    hi to all , i recently bought a 96 p38 4ltr petrol and am well pleased, it has a coil conversion on the suspension but to me its a little to high, what i wanted to know is are there different heights to the springs you can buy? as would want to replace for something a little lower!
  8. EAS Heights & Intermittent Errors

    Range Rover Mark II / P38
    I have done a lot of reading on the EAS system and have purchased a rebuild kit for the valve block which I intend to do next week. Some history on my truck. Previous owner replaced compressor and all 4 bags before I bought the truck. Eas sytem works good most of the time but sometimes the front...
Top