Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-17 of 202 Results
  1. Range Rover Mark III / L322
    Hi everyone, I’m new to the Land Rover community as I just purchased an ‘08 RR SC Westminster. My question is… can I use lowering links from an ‘08 HSE chassis? I am not sure if they are the same spec as each other. IMO, the height (even on access) is too high. I’ve done some research and...
  2. Range Rover Mark II / P38
    Is the hard rubber mount for the lower height sensor arm replaceable? I am looking for the attachment point from the lower sensor arm to the suspension(rear radius arm). Ive searched for a replacement but I haven't had any luck and I haven't seen any diagrams indicating a part number either. I...
  3. Range Rover Mark III / L322
    2008 range rover hse 150000 miles replaced bothfrn ir struts, lower contrl arm and bushings and compressor t about 120k. 4 weeks ago i replaced a lower radiator hose and then on the drivre home a suspension fault warning came on... since then it has displayed a few times and i have noticedon...
  4. Range Rover Sport / L320
    Hi, My 2006 RRS has a yellow suspension fault. The code reads a fault with the back driver side height sensor. On the 4x4 info screen I can see that tire is all the way down. However, physically all the tires are at the correct ride height. I plan to get the height sensor replaced but it will...
  5. Range Rover Mark II / P38
    So my old bus gets the occasional lean (1995 p38 with STC rear sensors) - when it happens its always low on the left side at standard height by about 20mm front and rear. Reading nanocom there are no faults, but I consistently get the front sensors both reading at around 148 (the configured...
  6. Range Rover Sport / L320
    Hi, I took my 2006 RRS into a mechanic to get the Brakes, Rotors & Brake Sensors changed. Everything was fine when I took it into the shop. However, after the job was done there was a suspension fault on the dash. He ran a scan and told me the left rear height sensor is not working. Just...
  7. Range Rover Velar / L560
    Hi! I just picked up my 2019 RR Velar last week and it came with factory black roof rails. I'm going to pick up the Thule AeroBlade Edge 7603 cross bars in black, and was planning to attach the LR Sports Roof Box - Large. I'm concerned about being able to drive into my garage with it on, and...
  8. Range Rover Classic
    The owners manual says 72", but my LWB measures at about 69" in height from floor to roof. I just put new springs on and they were stock height springs. What should the height be, and why would I be short? Thanks
  9. Range Rover Mark IV / L405
    Hi, I have a Range Rover Vogue 2014. When I open the doors should the suspension automatically lower itself to the exit height? Thanks.
  10. Range Rover Classic
    I want to put a couple crossbars on my ‘93 LWB using Thule rain gutter mount feet. They come in a few sizes- I want to go as low as possible. The two options are a 5” rise and a 8” rise. Has anyone had luck/clearance with the lower foot?
  11. Range Rover Mark III / L322
    Hi everyone, I’m another new owner of a 2005 RR who is looking to iron out some initial issues after purchase. I figure that I’ll outline all of the issues I’ve run into for your reading enjoyment, as I’ve always enjoyed reading and helping with new owners. We have a 2004 Disco, and I have owner...
  12. Range Rover Sport II / L494
    Is it possible to keep the ride height at the accessible level, lowest position instead of it going into standard ride height?
  13. Range Rover Sport / L320
    When parking for 10+ days is there a recommended height to set? Struts are fresh and not leaking. Just wondering. Figured access was the way to go but thought I'd poll the forum. Thanks!
  14. Range Rover Mark III / L322
    Hi all, I just recently purchased a 2010 Range Rover HSE with bad height sensors. Is there a technical difference between Hight sensors for a variable dampening suspension and sensors for a non-dampening suspension? Cheers
  15. Range Rover Mark II / P38
    Probably missed this from an earlier thread, however new issue to me. EAS remains in full height position, with the "do not exceed 35 mph warning and EAS fault showing. Any helpful ideas on where to start looking? Also, would very much like shupack's website, as I was going to replace the...
  16. Range Rover Mark II / P38
    OK ive fixed my engine problem after doing a head gasket , water /oil had run down the crank sensor cable sheath & causing bad connection all sweet now . But i have another question . Whats the standard ride height ? mines had the air bags swapped for springs at some...
  17. Range Rover Mark II / P38
    Greetings from Melbourne, Australia Over the last few weeks I've been having the random EAS height rise issue which seems to clear itself pretty quickly. There's plenty about this on this site which seems to suggest a failing driver pack. Several days ago the system seemed to take too long to...
1-17 of 202 Results