Range Rovers Forum banner
1-5 of 5 Results
  1. Range Rover Mark II / P38
    Being a ham fisted idiot, I've broken the idle by-pass boss off my air intake and am not having a lot of success trying to glue it back on. Has anyone succeeded? I made a spigot (yes I do own a small lathe) to go inside the boss and hold it in place but I would like to seal it properly. I've...
  2. Range Rover Mark III / L322
    What's the best glue to use to repair interior damage? The rip I have is on the drivers side door near the arm rest. See the attached images. A guy at the local car wash suggested gorilla glue. I'm worried about heat during the summer.
  3. Range Rover Mark III / L322
    Today, while cleaning my new 2004 RR, I found the rear door card pulling away. After finding a razor blade earlier in a strange place I was hoping to find cash from a drug deal in the door but no luck. Just the usual plastic retaining pin mounts coming Unglued or off. I've used many...
  4. Range Rover Sport / L320
    how to connect two seperated body panels? tape? glue? pics inside Recently had my RRS wrapped and he cleaned up the small things I mentioned, but I just now noticed these two and I am ~5 hours drive away from my parents house where I got it wrapped. 3 pics are from the upper tailgate where...
  5. Range Rover Classic
    The headliner material gets "pinched" in place at the sunroof with an edge molding. I'm wondering if the fabric should be glued to the metal edge or just use the edge molding to hold it in place. Any thoughts or experience with this?
1-5 of 5 Results