RangeRovers.net Forum banner

gearbox

  1. General Chatter
    Can anybody recommend a rebuilder in the North West of England? Thanks in advance Denis, Wigan.
  2. Range Rover Mark III / L322
    After I replaced the gearbox my 2002 l322 vogue will not even crank over. Steering unlocks and moves out to memory position. Dash Lights on as normal then when turning to start no click no starter lights then turn of one by one as normal. I did suspend the starter when the gearbox was removed...
  3. Range Rover Mark II / P38
    I got my shiny new Nanocom yesterday and was excited to see what sort of codes were hiding behind my Gearbox Fault. Unfortunately it is returning no codes. All the documentation I can find implies that I should have codes in the transmission controller and that the Nanocom should be able to...
  4. Range Rover Mark II / P38
    I picked up a 2000 Range Rover HSE 4.6 this weekend as a project. It has some issues and has been sitting for a year or two, I have experience reviving old BMWs so hopefully some of that patience I developed working through those problems will carry over. So first things first, I started down...
  5. Range Rover Classic
    Hello, So I think I might be able to get my hands on an LT85 (Santana) manual 5 speed transmission including matching transferbox, which was mated to a 3.5V8 (which is also included in the deal). In my car I have the same engine, but a 3 speed Torqueglide auto. Frankly I really dislike...
  6. Range Rover Mark III / L322
    Hi All. I have a 2002 4.4 L322 with 181k miles. I've owned it for 13k of those miles. It runs LPG. I don't know if it's original box. I've had the trans fluid and filter done 5k miles ago. It has a torque converter issue that makes the rumbling sound and 200rpm fluctuations on constant throttle...
  7. Range Rover Evoque / L538
    recently had a gearbox fault reduced traction come up.Took it to a garage they did a diagnostic check but showed no code faults said possibly electrical or mechanical and to monitor it. They also said possibly a short shift problem in the gearbox
  8. Range Rover Mark III / L322
    Some new symptoms for my MY 2010 L322 HSE Started getting the Gearbox Fault message on occasion. It reads the following fault: P0915 Gearshift position – circuit range / performance On occasion, the warning of stability control not working and some other relevant warnings. I forget the...
  9. Range Rover Mark III / L322
    Hi...first time to the forum with a question. Thanks in advance! I'm in London and have a 2006 L322 petrol 4.4l with 180k miles on it. The gearbox was rebuilt about six months ago. Leaking transmission cooler pipes were replaced a few weeks ago. Here's what is happening: The car drives fine and...
  10. Range Rover Mark II / P38
    Gents,I replaced a 4 liter with a 4.6.The cam from the 4.6 had signs of wear, the cam and lifters from the 4.0 are 15000kms old, engine ran alright, just worn, no ticking or knock, so I put the cam and lifters from the 4.0 in the 4.6.4.6 runs without any noises when cold, when she warms up...
  11. Range Rover Mark III / L322
    I have searched extensively online for a cause/solution to the gearbox issue I'm experiencing in my 2008 3.6TDV8 L322 but no joy so hopefully someone here can offer some pointers. On first startup putting the car into drive there is no drive. If the revs are raised gradually then sometimes when...
  12. Range Rover Mark II / P38
    After dropping the brats at school, I stopped in front of my gate to open it, left the car idling in Neutral, and when I got in and selected Drive it made a weird "grumbling" noise and didn't go into gear. Reverse was brief and then any selection after that was a no-go. Revving it in Drive got...
  13. Range Rover Mark III / L322
    Hi everyone! I own 2007 RR 3.6 tdv8. I started experiencing slipping from gearbox at gears 4, 5 and 6 followed by car goes into limp mode (limited gears only) appeared on the dash board, so I have checked transmission oil level, then changed it combined with filter, then checked the solenoids...
  14. Range Rover Mark II / P38
    My 2000 4.6 on top of everything else, now has a gearbox fault message and it't defaulted to third gear. No sweat nurse it home and have a look, unfortunately stopped off at the garden centre and it's still there as it doesn't recognise that it is in park so won't let me start it. Can I use my...
  15. Range Rover Mark II / P38
    I used my 2000 p38 yesterday everything as normal until I returned home,went to turn round and worked in reverse,changed to forward and no drive in any gear high/low ratio,anyone got any good ideas as to the problem.
  16. Range Rover Classic
    Hi - this is my first time here. I have an '84 4d Classic (sitting marooned in the floods in the bush in Kenya). At some stage it had an engine swap, the original V8 for a diesel from an '87 classic. The part I am trying to identify is a short shaft from the rear of the gear box that connects...
  17. Range Rover Mark II / P38
    Has anyone worked out the precise quantity of fluid required to get the level from the bottom mark to the top mark on the dip stick? Thanks
  18. Range Rover Mark II / P38
    I drove by a buddy’s house as he was trying to pull out a stubborn shrub with his brand new Chevy Silverado with no luck. I told him the Rover could do it in under 10 seconds. I am happy to report that I was right. But as I was doing it I got a gearbox fault and now after startup first gear...
  19. Range Rover Mark III / L322
    Has anyone changed their gearbox oil by what I would know as the “Gibbons Method”. Method involves removing the pipes from the cooler, return goes into a tub of fresh gearbo oil and return into empty tub (pipes will need temporary extensions). Start up the car and watch the fresh fluid flush...
  20. Range Rover Mark III / L322
    Hi everyone, hopefully someone can point me in the right direction and stop me wasting time and money. Right the problem... I have a 2003 range rover l322 4.4 petrol with the 5hp24 gearbox. When I go into drive and try to go it jumps/jerks/bangs forward into 1st and goes into failsafe prog. If...
Top