RangeRovers.net Forum banner

frame

  1. Rear plate frame options?

    Range Rover Sport II / L494
    With only 2 screws up top to affix your plate and frame, what are most people using? The big chrome frame from the dealership is starting to annoy me. :? Anyone know if there is a bracket that can be attached to the rear to allow for 4 screws on the plate? Similar to the previous gen model or...
  2. Arnott Gen3 air hose hard on frame

    Range Rover Mark II / P38
    I just installed rear Gen3 air springs today. My concern is that the top of the spring barely sits above the frame (chassis), so that where the air line enters the spring, the air line actually rubs on the frame. Is this normal? I didn't pay attention to know if the old one was the same. If it...
  3. Modifying 2006-2009 A frame bumper guard to 2010-2012

    Range Rover Mark III / L322
    Does anyone have a copy of the installation instructions for the bumper guard they could share? I'm interested to take a look to see if it could be modified to fit my 2011. I know the bumper contours are not the same after the facelift, but I'd like to prove it impossible before I give up on the...
  4. Upper tailgate frame trim

    Range Rover Classic
    A couple of years ago, I tore apart my rusted upper tailgate. Recently, I finally had a glass shop assemble an aluminum frame kit from Rovers North. I cannot find whatever piece of trim that used to cover these wires for the central locking and third tail light. Any help on finding the piece...
  5. Rusty Front Bumper Frame

    Range Rover Mark II / P38
    I finally got my front bumper off after I removed the rusty mounting bolts. The brush guard bolts were totally rusted and the head broke off of both bolts. So I removed the spacer and threaded on a long 10MM x 1.5 thread coupler and broke the rest of the bolt off so I could get my bumper off...
  6. tailgate window frame rust

    Range Rover Mark III / L322
    Hi all, what is the best way to remove the rust that is occurring on the tailgate window frame?
  7. window frame touch up

    Range Rover Mark III / L322
    So I'm almost certainly picking up a new old truck next week and it has a few chips and scratches. I know how I'll deal with the ones on the body, but no sure what to do with the black exterior window frames (see pic). Any ideas? Standard touch up paint/chip treatment?
  8. Boge load leveler top frame mount

    Range Rover Classic
    Does anyone have the top frame mount for a Boge load leveler from a Range Rover Classic they would part with?
  9. So we have the LR3 frame, why won't a lr3 bush bumper fit?

    Range Rover Sport / L320
    I'm trying to figure out why the rrs has 0 choices for bumpers. Any ideas?
  10. Frame Sliders for 03-12 FFRR

    Range Rover Mark III / L322
    Guys, It's been awhile since I've last posted in this area, but I thought I would share my designs with the forum for the sliders that used to be on my truck. Worked great and I used them a lot before I trade red her in for a 14' RRSSC. I can't seem to locate any picture of the siders from my...
  11. Anybody order this license plate frame before?

    Range Rover Sport II / L494
    I was just wondering whether anybody ordered this license plate frame before? Brushed Silver Finish Slimline — LRN91650 ( it's the brushed silver one ) If so can you please post some pics? I ordered the HSE and I was thinking this would probably match the grill and the rear. I need to display...
  12. Opinion on Frame rot.

    Range Rover Classic
    So, I was under the RRC today fixing my parking break issue and came across this. Ugh! :| One of the holes is the size of quarter and can be easily repaired. The other near the CAT on the passenger side has me a little concerned. It's probably going to be about two to three inches square...
  13. RRC 92 4 doors same frame Discovery 97 ?

    Range Rover Classic
    Hi/ciao, i am danilo from Italy, (and sorry for my bad english) i have one question: the frame Range rover TD VM 1992 are same Discovery 94-99, i like "swap" the discovery frame(and full engine/trans/axles) on Range classic body, if possible? (or whit minor modifications..) very thanks!
  14. Side Step Install - Frame Rail fasteners

    Range Rover Mark II / P38
    I'm planning on installing factory side steps, and I have everything but the actual fasteners that go into the frame rails to attach the hanging hardware. Instead of the dealer ($$$), can someone verify the actual size of the rivnuts needed? I went onto the fastenal site and found item...
  15. Check Engine Light On w/ P1314 Code + Strange Freeze Frame Data

    Range Rover Mark II / P38
    Check Engine Light On w/ P1314 Code + Strange Freeze Frame Data 1997 p38 4.0 Check engine light is on. Vehicle runs fine, starts fine, idles fine, speedo and tach are not doing anything strange. Throwing code p1314. Here is the freeze frame data: rpm 1726 VEH speed mph 0 fuel sys 1 CL...
  16. "Where does this go?" Found inside drivers door frame after doing lock/window maint.

    Range Rover Mark II / P38
    "Where does this go?" Found inside drivers door frame after doing lock/window maint. Okay - found this inside the drivers door just now after I replaced the drivers door latch mechanism - sadly the **** servo motor for the lock has failed, used parts blow... Anyway - if you know what this...
  17. replacing rear lift gate frame, i hear there is help here...please

    Range Rover Classic
    replacing rear lift gate frame, i hear there is help here...please Im purchasing a new frame for my 95 classics lift gate and the gentleman at atlantic pacific told me there was some good information here from others who had already done so. I would be very greatful to anyone who could at...
  18. Range Rover Sport 2010+ Genuine A Frame Protection Bar

    Range Rover Sport / L320
    Sorry for my ignorance. This part is a new one for me. Anyone buy this and install it? Is it visible? Anyone knows where it goes and what it looks like installed?
  19. Installed tow harness, shots w/ boat. Also new OE black RR Lic. frame design!

    Range Rover Sport / L320
    Installed tow harness, shots w/ boat. Also new OE black RR Lic. frame design! So I bit the bullet and bought the insanely expensive trailer harness kit and the receiver. Harness kit took about 2 hours, and removing the spare wasn't required as the instructions mentioned. Unfortunately it...
  20. Brake change time frame, Rotors & Pads at same time ?

    Range Rover Sport / L320
    I've a 2009 HSE with 23,000 miles. Dealer's service dept tells me I need to change all 4 brakes pads. I was also told that Land Rover requires that all Rotors also be replaced when ever the pads are changed. Total cost $1740; is this typical ? While I've heard that brake pads wear fast on...
Top