Search Results for ‘fill’

Hi, I've done a search and still no luck. Can anyone please tell me how to read the clutch pressures / 'adaption values' in the L322 ZF gearbox, without full Land Rover diagnostic software? I can find nobody on any L322 forums who mentions this. My car is a 2006 with the 6hp26 ZF transmission...

Short 6HP26/28 Fluid Change Writeup - For 2006-2012 L322s First of all, you’ll need a few things: 6 Quarts of TYK500050 Lifeguard 6 or XT6QSP Ford Motorcraft MerconSP, SP has a 2% difference to LG6, safe to use as an inexpensive alternative A 24-15-2-333-903 ZF Filtran filter, a metal pan for...

Hi planning on drain & fill transmission myself 2007 RRS HSE, (putting in same amount that got out) Somebody that have done it in the past can tell me if 5 liters its enough ? And if better with fluid cold or hot, and at parked at what angle to get the most fluid out ? Thank you

Drained the front transfer case, gosh my S7 mangled my thread title. I got the brown mud out, it was awful, but I can't tell which bolt is for filling. Anybody know?

Hey guys, had a suspension fault and noticed the compressor wasn't running. I'll detail the issues in anther thread but for now is there anyway to fill the compressor tank manually?

Anyone know what your miles to empty show after filling up? I show 370 which averages to a little over 13mpg. Tks!!

HI all followed the instructions to empty the coolant by twisted the small red knob bottom drivers side of radiator filled with dexcool now whenever I check the reservoir keeps showing low I suspect coolant is coming out through the overflow on the reservoir I'm thinking I have an air lock...

So my poor wife takes our newly acquired 2004 L322 to the gas station and can't get the gas fill to unlock, i told her to press the central lock and try to get all the doors unlocked - the rear doors don't seem to unlock with the central locking switch. She had to unlock everything with her...

Hello Im having the vibration hum issue on my 2005 Hse. Yes the revs are dropping with the noise. I read all post pointing towards the torque converter. I purchased a remanufactured unit from torqueconverter1.com. My questions is....Should I try a full fluid flush(11 liters) or half fluid...

2003 Range Rover with 125k miles. I bought this 3 months ago. I am very mechanical and have rebuild engines, brakes, suspension, and the list goes on. Accoding to the shop records the previous owner gave me, he had the transmission filter and fluid changed last summer. But, i noticed the...

Awful noise after coolant drain & fill. What did I break? You can hear the noise. The bubbles have stopped. Its cold outside -13C. Engine temp is stable at whatever 768mV is according to IIDTOOL. 1. Opened coolant fill cap. opened blood screw next to coolant cap. Opened the bleed...

I bought a used RRS L320 SDV6 three months ago and love it. Except when it comes to filling up with diesel. The filling nozzle cuts off at anything more than a very gentle fill rate so it takes me ages to fill up. Furthermore, because the nozzle cuts off so readily I can't tell when the tank is...

So I take my '14 v8 to the gas station for a fill, start the gas pump, and go inside the station to grab a drink. Come out, not looking, and drive off. Seconds later, I realize that the tank isn't full. The next day, I go to fill up again and actually wait there to see if my tank fills. Sure...

Since my newly purchased P38 doesn't have an available service record I would like to get the transmission fluid flushed or do a drain and fill however I have been told that it can regularly cause the clutch pack to slip if it hadn't been done on a regular basis in the past. My transmission...

I have bought some valves so i can pump up each air bag to make sure there is no leaks (it seemed to be dropping over night) i have just rebuilt compressor just need to know what psi i can pump into system seen a lot of threads about this but cant find actual psi car starts lifting at about...

I'm about to flush my cooling system and add new antifreeze but don't seem to have a fill tower as shown in the manual. Did they drop this on the 4.2 engine? Mine's a 1994 LSE. Many thanks

For those that have helped with my various threads to get my truck back on the road; I have the added coolant everywhere that I can think of. I filled the back flow; filled the crank case/block. But I have yet to fill the radiator. So here is the question: " If I crank my rig with the cap off...

Hi Does anyone know the internal diameter of the short pipe which joins the fuel tank to the filler pipe? I need to take my tank out again to replace a new faulty fuel pump (Britpart) and I do not want to wrestle with the old hardened rubber pipe again and instead will replace it with a...

When I fill up I have to do it at about half speed or it thinks its full and shuts off. Today I took a look at the filler neck and couldn't really see anything wrong. Can anybody point me in the right direction about what to tackle next? There appears to be a switch that is opened when the...