fail

Hello everyone, So as the title says I have the dreaded 'Trans Fail Prog' error on my 2004 L322 4.4. I have read the many of the threads on the forum regarding this message and there has been some excellent help given. I think I have an idea what needs to be done to rectify the problem...

]hi guys I got the Trans fail safe warning message ping up today along with the car locking to 4th gear (can't change gears manually either). I managed to limp the car home and hooked my icarsoft scanner up which is throwing the following faults: P0755 State: Plausability Fault. Shift Solenoid...

Code reader says incorrect gear ratio goes in 5 gear soon as I pull away any help please.

trans fail safe program from cold start Report post hi guys anyone come across this , on my 2004 v8 petrol i am getting trans fail safe come on screen straight away on start up sometimes or maybe 30 sec ,1 min or 5 min also when i get this come on screen i have limited drive feels like i am...

Hi I must be mad but bought another MOT fail 1997 V8, it was very cheap and with LPG and a RPI rebuilt engine...It may just live to fight another day! Okay using my Nanocom under SPS1 it reports " The harness check resistor is measuring open circuit." , well I checked the passenger airbag...

Hello ! When i start the engine up or when i just put the contact key in, it shows no DRPN green lights on the dashboard and i have Transmision Fail message in the dashboard. The car is moving forward and R -reverse without problems but when i put it in D, the car seems to start from a higher...

Hi guys I need help I have a leak from the brake pipe atvrhe rear RHS It looks a pig to get to as its high up near the chassis Any advice Thanks Sent from my GT-N8010 using Tapatalk

My Range Rover Autobiography has repeatedly had the power steering fail, no lights or warnings, the steering "seizes up" making steering extremely difficult. I am strong but had to fight to steer at low speeds turning left through a light as if the steering was fighting against me. Steering is...

128,000 miles. For past nine months only stop and go traffic. Check engine light is on and has been corrected by dealership but it goes back on. Just had front suspension fixed. What do I need to do to pass the smog test if the dealership can't find the problem with the check engine light. Code...

Hi guys, so here is the case - for the past months i've been having problems with occasional overheating. I postes a thread when the overhating started and i got a lot of suggestions, and tried all of them. New thermostat, water pump, system flush, radiator chek, system bleeding, but still the...

Ok geez here it goes driving L322 MKIII 2003 139K when i noticed the battery light come on so i turn the vehicle off and it would not crank or turn over. Coasted it back to the work place and put a new battery and still no crank or turn over. Check the starter a ok and can jump the car with...

Long story but I figured I would post here as I could not find anyone anywhere referencing the fault code P1710. It showed on my scanner as MGF Trans Failure but I found nothing on the internet. Here's what happened. I'm driving to work and about 5 miles into my trip my 2003 L322 suddenly...

My daughter bought a 2004 Range Rover HSE 4.4L and roughly 5000-8000 miles ago she had an transmission fail safe mode appear. We had a rebuilt transmission installed. She also had to have the engine replaced recently as well. Just the other day she received the transmission fail safe appear...

We try to hold ourselves to a higher standard, but we are let down. https://www.youtube.com/watch?v=hFo0outqkmU

Two weeks ago my EAS relay failed - compressor would not work I replaced it with a 30 amp Bosch relay Yesterday my compressor stopped working The compressor works if I bypass the relay The black Bosch relay is distorted, swollen and twisted, it looks like it overheated Is the yellow Siemens...

Hi, This is my first post after joining this site, so I hope you guys can help! I recently brought my first Range Rover a 2002 L322 HSE, she is Java Black. I have had the Air Suspension struts replaced, a tensioning arm replaced on a drive belt, new air conditioning and finally a sensor...

When I start driving my truck feels like it is getting bumped going into 1st gear when it's warm, after that it's fine once it struggles to get into 1st gear. Some people say it's the transfer shift motor. Anybody got some advice rrphil if you there. Don't know where to start, this problem...

hi L322 2003 v8 something strange happens at engine start. when i start the engine with gear in P , it goes into " trans fail safe mode " and the P green indicator lights off. when I start the engine with gear in N position, it sometimes starts normally ,and then everything works perfectly...

so my son bought him self a 2004 range rover first day he went up in the hills and broke his cv axel i am assuming going to fact in Lo. We have replaced the axel not the darn thing is stuck in Lo with the fail safe warning. The transmission seems to work fin in Lo when I remove the...

hi all. so i know theirs an abundance of posts with the whole limp mode but i just had some specific questions. so first off. 2003 range rover 4.4 bmw v8 120000 miles. new battery i recently replaced the the alternator with an ebay special one. which was probably my mistake but i did a volt...