RangeRovers.net Forum banner

distribution

  1. Distribution belt maintenance

    Range Rover Mark III / L322
    I'm going to change distribution belts soon. Sailing through internet I have noticed that the market offers the "belt tensioner", but the M62 has another thing like an "arm" called "driver tensioner". I'm asking opinions of what is more important or must be replaced (The truck has 188000km -...
  2. Cracked Heater Box Distribution Flap Lever

    Range Rover Mark II / P38
    I set about replacing the blend motors on my '97 P38, while also taking the opportunity to replace a warped dash. Everything was going great until I arrived at the left side distribution flap lever and found the mechanism cracked where the blend motor engages the gear to move the flap. Attempts...
  3. HEVAC - Distribution motor short to positive?

    Range Rover Mark II / P38
    Trying to sort out my HEVAC issues, but I'm a bit stumped by the last one. Cheque book symbol naturally lit up, immediately when turning on the ignition. The fault I've got is 'Distribution motor is short circuit to positive'. Clear and it comes straight back, and it doesn't respond to any...
  4. Distribution Blend Motor Fault Code (17) THE DISTRIBUTION MOTOR FEEDBACK (FAULT TYPE

    Range Rover Mark II / P38
    Distribution Blend Motor Fault Code (17) THE DISTRIBUTION MOTOR FEEDBACK (FAULT TYPE Hi All I am needing help with regards the directional blend motor, I was getting a fault code on my Nanocom code reader saying (14) THE DISTRIBUTION MOTOR IS SHORT (FAULT TYPE = CURRENT) I've changed the...
  5. Sticking distribution flaps

    Range Rover Mark II / P38
    I am having a problem with my aircon,sure its distrabution flaps sticking or just not working, is there anything I can do to try and sort it or is it time to sell one of the children and send it to a garage?
  6. HEVAC Distribution Servo (Blend Motor) Issue

    Range Rover Mark II / P38
    All, I know the HeVAC/blend motors/servos have been rehashed many times on this site. I have read many posts that have been quite helpful. I am currently of the opinion that my motors are not bad and the dampers/vanes are stuck or something. Following are details: 1. The books symbol is...
  7. Unusual heat distribution problem - not blend motors/flaps I think

    Range Rover Mark II / P38
    Unusual heat distribution problem - not blend motors/flaps I think Hi, I have a heat distribution problem I haven't been able to find the answer to searching the forum. When starting, everything is ok with my heater. Heat comes on relatively quickly (good since I'm in cold Denmark). All heat...
  8. Which one is the distribution servo?

    Range Rover Mark II / P38
    Hi, Before asking, i went on the main site and it says it's the upper one. See: But the Rave manual says it's the lower one. Who knows? Thanks Florent
Top