RangeRovers.net Forum banner

communicating

  1. ECUs not communicating

    Range Rover Sport / L320
    Hi guys, I'm new on this forum and have been battling for 2 months with a problem on my Range Rover 2007 model, V8 sport, super-charge. When I switch the ignition on, the hazards immediately starts flashing, heat gauge goes to the top, and the red alarm light at the bottom of the cluster keeps...
  2. ABS not communicating with ECU? (air suspension inactive)

    Range Rover Mark III / L322
    I am trying to clear an "air suspension inactive" on the rover. When I connect my icarsoft, it says I have a Can Bus error. So I looked a little farther. I went into the steering angle sensor and ABS and I got an error stating the ABS is not communicating with the ECU. I tried to clear it...
  3. abs not communicating with steering module

    Range Rover Mark III / L322
    I have a 2004 range rover and dealer said the abs is not communicating with the steering module I sent the abs module off to have it repaired but it still wont communicate with steering module any ideas anyone?
  4. OBDII port not communicating

    Range Rover Mark II / P38
    Hi folks I need to use my faultmate FCR to reset the SRS error code now that I've fixed (or think I've fixed) the cause of the problem but I can't get the ECU to respond. The faultmate powers up ok, and gives me the menu but every single menu option to read codes fails with "COMM FAILURE"...
  5. EAS kicker not communicating

    Diagnostic Equipment
    Hey guys, Ok so I'm not new to this site but I can't remember my password but I'm in need of some urgent help. It's the dreaded EAS which I know has been covered time andtime again and I have spent hours going through the forums but to no avail. Ok so I bought my old P38 2.5D back as it had not...
  6. Nanocom evo 2 not communicating with EAS

    Diagnostic Equipment
    Hello friends, my new Nanocom evolution 2 Does not communicate with my EAS module. ( P38 1999 Motronic ) I talked to Black Box Solution they think the problem is within my vehicle. Unfortunately Black Box Solution is unable to tel me how exactly connect the nanocom evo 2 in order to get...
  7. eas module not communicating

    Range Rover Mark III / L322
    hello everyone! have this problem with my 2002 l322 tdv6. the suspension is locked into midlle. there are no leds up at the control switch for the suspension. i tried to find the problem using a launch and a bosch diagnosis units. could acces all modules, but the eas one. it gives the...
Top