codes

I have searched the forums for a good hour or two, and haven't seen anything that answers my question.. So here is my question. How likely is it for all 4 ride sensors to go bad at once? None of my wheels are bouncing on the 4x4 menu. BUT in my code reader I have 0 inches on all 4 ride sensors...

Hi all, I have a 2006 Range Rover Sport 4.2 V8. The check engine light is on and giving P0171 (System too lean bank 1) & P0173 (Fuel trim malfunction bank 2). I have cleaned the MAF sensor but this has not changed anything. Has anybody else experienced this and have any advice? Thanks in...

Hey all! Been running the velocity tune for about 8k miles now no issues. Had a check engine light pop up this morning and read the DTC codes with my velocity tool. P0147 seems to be an overheating oxygen sensor? 2016 V8. P167F I’m not sure about though. Google pointed me to a non...

Got these codes after a heavy downpour and the truck was outside the garage at the time, totally unrelated, fan clutch EGR and EVAP errors. I replaced the fan because it was a bit loose anyway. Turned out to be a 10 amp fuse, 3rd one down on the left side just has a pic of the engine on the fuse...

There should probably be a flow chart on solving this but this was my experience. After 1 year of running an lower temp t stat nos from an older diesel bmw-plug and play except for the electrical control wiring I started getting P 0128 codes tedfollowed by 131 and 134 codes iirc. So coming up...

My CEL came on with one code not too long ago and i just checked it again and now i have three what are these for? error code p1590 error code p1669- I believe its for the ECU fan but i had this replaced last summer for the same code. error code P0440 "Evaporative Emission System" 2000 Range...

This is regarding a 2007 HSE with 190k miles. I'll start off by saying I have searched and read through every relevant post on this topic this website and google has to offer, so I'll ask a few different questions than what others have asked. I recently had my fuel pump fail (one day vehicle...

Hi, I have a 2006 RR Vogue Supercharged and have been having intermittent "system engine fault" messages followed by the car going into limp mode until restarted. I does not however cause the check engine light to go on. I brought it to a garage today to have them read the codes but they said...

Does anyone know what regulates/controls the rolling key code on a 2003 Range Rover 4.4L? I keep getting a rolling code error and sometime a no start until I clear the fault. Have already replaced with a new key, but did not correct issue. Guess I should change out whatever component controls...

Does anyone know where I can find the color codes for our trucks? I looked for the RPO sticker and couldn't find it. I just need a bottle of touch up.

i have a 06 RRS SC i've been getting the following codes of P2096, P2098 and P2135 after i replaced the O2 sensors. I know for a fact if i were to floor it, it would go into limp home mode and the "reduced engine performance' prompt will show. I know that P2135 pertains to the throttle position...

Hi, Wondering if anyone has ideas or advice for an issue that came up today on my 2013 RR HSE. I drove my car about 45 miles today and all was fine. Got back in my car to go home and multiple fault codes came on all at once. My car is driving fine, the fault codes are all solid amber...

I live in New Orleans and haven't found a single shop that will work on my car. I don't have the acumen or space to do anything myself. But at this point, I'd like to know how bad it is. So far, I have just been given the codes and told "something is going on" - everything from warped head...

I have read in some threads in this forum that by switching the wires of the O2 sensors that codes will go away for good, however, no one specifically explains how are they switched. Can someone please be specific on how to do this. I have installed new cats, no cracks, smoke tested etc, etc...

Hi all, I have a problem connecting code readers to my l332 vogue SE tdv8. I have two code readers that both come up with LINK ERROR on the screen when trying to scan through the OBD2 port. I have checked all fuses and nothing is blown, both these readers work perfectly with my other two cars...

Just finished a timing chain guide job, bought it tore apart. Relaxed guides and reassembled. Did new plugs and filters including fuel filter. Any insight on where to start with this list

As a proud owner of a 2004 Rover and a nerd towards original equipment, I need to find the color codes for the secondary trim. My drivers door handle and hood vent are in bad need of painting. Color appears to be maybe a grey/silver? I want to be consistent with the rest of the Rover. Also...

Have a 2006 HSE. P0171 and P0174 showed up a about a month ago (at the same time). Got a smog need to pass in a couple weeks so have started to troubleshoot. After a bit of research, I think I've narrowed it to MAF and/or fuel supply. Here's why... 1) At IDLE long term fuel trims are around...

I have a check engine light and three codes that I have erased a few times but they keep coming back. Two of them are are 02 sensor bank 1 and 2, downstream. So, I removed the rear most 02 sensors and cleaned them and reinstalled. I figured I have nothing to lose by trying that. I will order...

I got a code P0101 yesterday and cleaned both sensor with mass airflow cleaner. Now, this morning I got another code which is P00AD. My question is which air intake sensor is bank 2? Is it the passenger side or driver side?