clutch

What direction does a fan clutch spin off for removal. I am facing engine. Clockwise or counter clock wise

Anybody tried one yet? Ideally it would have a controller that monitors the engine or rad temps.

Hello gents, I have a 2006 RRSC with 120k miles on it. I changed the pan/oil a year or so ago just because I had a leak from the drain and figured it was a good time to change the pan/oil. Did that and had some slipping under moderate to hard acceleration (which never happened before). I...

Hello, Prior to cold air completely going out, there were days it blew luke warm, then back cold. Now there is no cold air at all. Took it in today to have it diagnosed. AC System diagnosed: Dye & R134 Freon was added. No leaks, but ac not functioning. Getting power to compressor, but the ac...

Hi Guy's I've had my 6th p38 for 2 years & with the colder weather noticed that the heaters art getting above warm. The temperature gauge doesn't move off the start point, so I'm thinking that its overcooling due to the viscous clutch. Now looking around, i noticed that if you search for a...

Hi I trying to get the A/C working on my 1997 4.6 HSE Range Rover. I have a Hawkeye diagnostic tool and this was telling me there was a fault with the compressor clutch. I could see from looking at this under the bonnet that it didn't seem to be engaging. I've checked the relays and fuses and...

As best as I can tell when the outside air temp where I live reaches above about 95 my ac will not cool below 60 at the vent. The 5 amp compressor clutch fuse and surrounding plastic gets scalding hot to the touch and when I park and put it in park the idle jumps and hot air blows out of the...

Hello Roverites, I can't come up with a wiring diagram on this fan clutch, Radiator was holed leaked out all the coolant, when I pulled the radiator I discovered the real problem. I was going to hard wire this thing but the plug from the body harness side has been reduced to bare wires so...

So I recently purchased a 96 4.6 upon purchase AC/Heater worked no issue. Went on a road trip got back and alternator died, installed new alternator, AC/Heat continued to work and recently stopped blowing completely out of now where, checked relays and nothing seems to be wrong with them...

Hi, When we bought our Range Rover the previous owner told us the AC compressor failed. We ordered a used compressor so for preparations, this weekend I had a look at the compressor I noticed the following: I can turn around the outside part (clutch plate?) by hand, but I'm unable to turn the...

Has anyone ever had this issue on their 2010+ range? I remember reading that it was a common problem and would like to know the symptoms of the issue as I think I may have a problem with my fan

Hi, Got to work this morning and when I switched off the engine I heard a ticking noise from under the hood. After further investigation I found the A/C compressor clutch ticked as it slowed down when disengaged. The clutch also seems to take slightly longer to come to a stop when disengaged...

Hi all, great forum BTW. Besides my introduction, this is my first post here and I thought this would be a good thing to post as many have needed to do the procedure of removing the A/C shim to get the A/C working correctly. I've read about the battery connection directly to the wires to...

Hey guys, I'm trying to figure out what this circular part is on the back of the AC compressor(see attached). It seems to be the source of my AC compressor clutch not kicking on. I have a nice strong 13+ when I probe the line prior to that piece but after I got nothing. What is it, how can I...

Hi all, I have a 1994 4.0 P38. And there is a problem with AC power supply - only 9-10 volts on clutch, and, as a result, clutch works bad. If I connect 12 volt directly - clutch works fine. Also, switch works ok - if AC disabled, there is no voltage, if on - this reduced voltage I found a...

I have an 06 Range Rover with the Jaguar engine. I'm trying to take the fan clutch out I got the tool but the nut doesn't moved in hitting it toward the driver side ? Question is that they way the fan come out? Is clockwise or counterclockwise? Help please

I found this information last year when I replaced the bearing on my 2000 Disco II last year. I purchased an extra bearing just in case and ended up needing it for the P38. I ended up doing the procedure on my P38 yesterday and it is exactly the same compressor. Credit to sactodisco over at...

the fluid Is leaking out of the bell housing wading plug hole. im hoping this means I simply need to replace the slave cylinder. any thoughts guys?

Should the A/C compressor clutch spin freely when installed and serviced on my rover? I think I have pin pointed the issue with the noise from my a/c compressor. It has a growl/whine noise in the cabin area ONLY when the a/c was turned on. I have checked all lines and ducting in the system...

Please forgive this if it's not in the correct place on forum I have a plight I am in that maybe rr Phil and others will advise on has soon has he can I am at moment in marazion in cornwall on holiday with my 2 children has a single full time parent. My range rover l322 BMW m 62 engine...