2010 RRSC, got low fob battery indicator error. Replaced battery, locked/unlocked in multiple combinations (on/off/accessories/inside/outside) - any advice? Need diagnosis to clear?
Will post some images on current look too. Blacked it out a bit since last post.
I placed an order for a RRS V8 Supercharged, and the sales guy gave me the following options:
Door Edge Guards - $295
Front Window Tint - $295
Clear Bra - $1,795
Permaplate - $1395
Now, I'm not going to pay $295 for them to tint two windows, when I can get it much cheaper at a tint shop, so...
So I recently went into the dealer for my second oil change at 18,500 miles. They had also done the first oil change at 8k miles. When I called to schedule the oil change they indicated I need an annual service. I asked the cost and it was a little over $800. I asked what that involved and it...
This is my first RRS MY18, I got the SW update for dual pro system. The reason is the system was rebooted once I was driving.
The dealer update my car, but in the menu of center instrumental gauge, the last alarm is still there?
I had and have other brand, BMW, MB, etc I believe that the...
I'm getting a couple of minor faults that I want to clear without clearing everything out that my mechanic would want to see. I can get to the "clear by specific ECU" (or whatever it says) but it won't let me go further, and I can only do a general clear. I've tried twice now for different...
Hope everyone's well. First time using this forum so please be kind! :-)
I was wondering if somebody could give me some advice regarding a clear coat peeling issue.
We have an L322 (2006) 35th Anniversary Range Rover on which the clear coat has started peeling significantly on the...
I have a P38 - 4.0 V8 Bosch - 1999. It has the orange indicators and would like to convert to the later clear indicators. I have found the part numbers for the front:
- Orange indicators (to XA430701) -> AMR2690 & AMR 2688
- Clear indicators (from YA430702) -> XBD100920 & XBD100930
Hi can anyone help with a Bluetooth issue I have.
I'm able to answer calls but it seems to be the same length of time every time I loose the call.
Can answer but not the clearest conversation then gradually gets worse. Say 1 Min and the call cuts off .
I’ve been replacing almost all of these small lightbulbs in the switches, the green and orange ones.
The bulb in the master light switch eventually broke and I assumed it was a small green one like the others.
Turns out it wasn’t.
Does anyone know or have seen this type of bulb before? It...
A coupe of things...
I've searched and couldn't find what anything so here goes.
I can hear a slight metallic rattle under load that appears to go away when you hit higher revs or as my guess, when oil gets pumped up to higher pressure. It's just had engine flush, oil, filter and PCV...
I was thinking of getting a clear bra install for the front of my RR. I have spoken to a few detail shop that recommended Xpel. Has anyone put this products on their vehicle before and if so do you recommend it? I hate seeing swirl marks on my car and I heard this product will help it from...
I'm looking into paint protection as i have a new white RR/SVR ordered and was little over whelmed with all the new products out there.
In 2013 i bought a new mocha colored caddy and dealer sold me Xzilon protection package for interior/exterior.
The left side of truck...
Re: 2010 RRS TPMS sensors programming. No clear answer
Hey guys just a quick question that I haven't really seen a concrete answer for.
On the 2010-13 models do new TPMS sensors need to be programmed to the module or is it just a simple matter of installing and driving for 10 minutes on the...
My 93 RRC is running rich. Starts fine when cold but hard starting after it warms up. Code reader below the seat shows "14", coolant temp sensor. Replaced sensor and still won't clear. Plugged another correct ECU to it and got the same result. All I can think is there is a break in the...
So I'm doing some research on paint coatings, for the 2 SVRs that I just ordered recently. I have the 3m clear bra on my current SVR, but I've been reading where these new coatings Opticoat and ceramic pro you don't need the clear film? Does anyone have any experience with these new products...