RangeRovers.net Forum banner


  1. Suspension heights - calibration needed?

    Range Rover Sport II / L494
    Can anyone with a 2014 RRS on 21" wheels possibly do me a favour? Can someone measure wheel centre to arch, vertically, front and rear? For Access height, Normal height and Off-road height? I have a feeling my car is out of whack and needs a recalibration but I'd like to have some numbers to...
  2. EAS calibration

    Range Rover Mark III / L322
    Has anyone used the new "Guided Calibration" method available using the IIDtool with Bluetooth for calibrating the EAS on their Range Rover yet? I just noticed the new method while playing around with the my IIDtool. Seems like its pretty user friendly and no math required now, just a tape measure.

    Range Rover Mark IV / L405
    The dealer just performed this service action. Anyone knows what this is all about?
  4. EAS cannot conect for suspension calibration

    Range Rover Mark II / P38
    Hello, I have a P38. In the normal height suspension drops every 30 seconds, then climbs back up. The compressor is therefore almost all the time ON and I worry that it'll die. Currently I drive into the lower position. I assume that the problem is in the front sensors for height. Am I...
  5. EAS calibration issue?

    Range Rover Mark II / P38
    Hello again all, Well the saga continues, I am still getting the intermittent fault on the EAS at or around 50 on the dual carriageway. Always the same fault code as in: Cannot Lower FR FR Valve Stuck Shut I have replaced the valve block with a rebuilt unit, replaced the driver unit and...
  6. Suspension calibration tool

    Range Rover Classic
    Anyone know where i can buy a tool to calibrate the heights of my 2006 supercharged range rover?
  7. Calibration Tool Explained?

    GAP Diagnostic
    Hey Guys I'm sorry maybe I'm an idiot haha. Could someone please explain the "Sample EAS Calibration Calc" that they have online? I guess my questions are: "New and old X calibrations Values" are from the Live values/ Suspension menu/ calibration readings? Where are A, B, C and D Values...
  8. Seat Switch / Control Unit Calibration

    Range Rover Sport / L320
    Hey all, I have a 2010 RRS SC, and I was wondering if there was a procedure to re-synch the seat control unit? On my Mercedes, it was as simple as moving the seat to all extents (up, down, front, back), but i did that with my truck and it still is not working correctly. It only moves back to a...
  9. Air Suspension Sensor Calibration Necessary?

    Range Rover Sport / L320
    Hi everyone, I've been having issues with the dreaded suspension faults on my 2006 Range Rover Sport. After not getting much joy out of my "local" (600kms away) authorised Land Rover service centre I decided to get myself an iCarsoft i930 diagnostic tool. Plugging it in tells me I've had...
  10. Airbag calibration and software recall

    Range Rover Mark IV / L405
  11. eas- valve stuck faults and calibration

    Range Rover Mark II / P38
    I recently changed all the suspension bags and also the shocks. The bags were old and shocks leaking. I thought that this will solve also the problem- rear end stayes lower than front(only in high mode it is like it should). I just got the rsw software and cable few days back. Got it all working...
  12. 2014 RRS pano roof calibration?

    Range Rover Sport II / L494
    hi all. i have been away from my home for the past 3 month and just got back, wanted to drive my car, found the sunroof stop working... is there a way to reset it or calibrate it? thank you
  13. L322 Air Suspension Calibration

    Range Rover Mark III / L322
    Hi, could anyone please help me. My Range Rover seems to be sitting too low by about 2 inches on all 4 corners. I have been reading about the RSW All Comms. anywhere I can get this done around Birmingham without going direct to Land Rover?? Many thanks for any help.
  14. Air suspension calibration

    Range Rover Mark II / P38
    Anybody know a good place in So Cal to ha e the air suspension calibrated? My right front seems a little Lowe or my left rear is a little high. It doesn't seem to be a leak since it's always like this. Hoping not to pay an arm and a leg to do this, so any info is appreciated.
  15. EAS calibration

    Range Rover Mark II / P38
    first i am sorry for may bad english :-( how can i fix rear right sensor value i clicked write for new value and done. but after i clicked get button it is 244 again. thanks
  16. EAS Calibration Blocks

    Range Rover Mark II / P38
    So I didn't have much to do today so decided to calibrate my EAS system. It was looking fractionally lopsided and the last time I had it jacked up I got an EAS fault from the right rear, plus the front end has jiggled a bit at junctions. I've rebuilt the valve block already and checked for leaks...
  17. EAS Calibration

    Range Rover Mark II / P38
    The repair details page states that calibration should be done like this The system has to be calibrated after a sensor is replaced. Calibration can only be accomplished with the dealer's Test Book or equivalent (Rovacom or Autologic). Special spacers are placed between the axles and bump stops...
  18. maf re calibration ???

    Range Rover Mark II / P38
    Hi iam about to put a new maf on my 4.6 thor engined rangie do i need to get it calibrated or will it do its self :?:?
  19. Problem with calibration EAS

    Diagnostic Equipment
    Hi all! I'm new to the forum and want to say hello. I bought a P38 in 1996. I bought the program and EAS cable calibration. Unfortunately, after you connect your not working properly and reads the wrong information. STATUS is to change the red and green, I can not make any changes. What do I...
  20. suspension issue - vehicle calibration

    Range Rover Mark III / L322
    i have had some air suspension issues. so far i have had to change the compressor, and now a front suspension strut. The current issue is that the vehicle will not calibrate. The rr thinks its on a normal ride height when is actually on high and thinks it on low when its in a standard height...