RangeRovers.net Forum banner

bottom

  1. rear bottom door not locking

    Range Rover Mark III / L322
    have WD and LM the locks but on shuting the door it will not lock in place top door ok any one got any pos help thanks for looking. bill
  2. Front Seat Bottom Material, does anyone know where I can find it?

    Range Rover Mark II / P38
    Front Seat Bottom Material, does anyone know where I can find it? I would like to redo the seat bottoms (Front) eventually on my Rover. Does anyone know where I can get a set, I can not find the Tan ones anywhere! Mine are the 4.6 seats that look like the mercedes style.
  3. Bottom end wear.

    Range Rover Mark II / P38
    Chassing down an oil pressure problem, I'm pretty sure it's the oil pump but am wondering what the 4.6s are like with big end and main wear. It's got 247000 km on it, and serviced as per land rover schedule. Also what clearance plasti-guage should I get?
  4. Screw for bottom back of seat in 2004 Range Rover HSE

    Range Rover Mark III / L322
    Hello all.. I have a 2004 Range Rover. Im sure you all are familiar with how the plastic at the bottom starts to crack at the bottom where the seat controls are located. The screw in the back of my seat has come out. Im referring to the screw at the bottom of the seat that holds the plastic...
  5. Bypassing the bottom seat heater?

    Range Rover Mark II / P38
    I read here- http://www.rangerovers.net/repairdetails/seats/seatheat.html that it's possible to bypass the bottom seat heater so that the back one will still work. It says that this for 99 and up my's. Does anyone know if it can be done on a '98? And if it's the same?
  6. Noisy bottom end - L322, BMW engine

    Range Rover Mark III / L322
    Hi, I recently bought a 2005 BMW engined RR with 125 k km's. My feeling is it has been run for some time without changing the oil and the bottom end is noisy when you start it. It runs well, seems powerful enough and when going is relatively quiet. Any thoughts as to what the damage is likely...
  7. P38 Bottom Tailgate Actuator Rod Detached

    Range Rover Mark II / P38
    Hi, First post on here. I am having a major issue with my P38 bottom tailgate. The top half works as normal. The bottom left actuator rod is functioning OK, but the bottom right actuator rod has unseated on both sides i.e. it is basically floating in the tailgate. Is there any way to...
  8. Major problem removing bottom clip on front air spring - HELP!!!!

    Range Rover Mark II / P38
    Major problem removing bottom clip on front air spring - HELP!!!! I'm in the process of changing the driver's side (UK) airspring on my P38 and hit a major impass. Everything went fine until I tried to remove the lower pin (the only thing now stopping me getting the old spring out). It's stuck...
  9. Driver seat bottom loose

    Range Rover Mark III / L322
    Recently I've noticed my seat bottom clicks back and forth (or so it feels) when accelerating and braking. I've looked under the seat and I don't see any bolts to tighten that hold the seat bottom to the frame that could be loose. I did however notice that the tilt assembly in the front of the...
Top