RangeRovers.net Forum banner


  1. Traction Control issue after fitting suspension dust boots

    Range Rover Mark II / P38
    Hi All, My P38 failed the MOT on split dust boots on both front lower suspension ball joints and leaking rear oil seal. I have had to remove the front brake calipers, discs and hubs complete with drive shafts to be able to change the lower ball joint dust boot. I did have to use a clamp to...
  2. Which size boots for our ball joints?

    Range Rover Mark II / P38
    Boots are disintegrated off the ball joints, but ball joints are still very tight. Want to just replace the boots packed with fresh grease. Can anyone indicate what size the boots are? https://polyboots.com/tie-rod-end-and-ball-joint-boot-14x31x23-mm-black-type-1
  3. RRC 1995 Windscreen Wiper Rubber boots replacement

    Range Rover Classic
    Can anyone help me with where I can find some replacement rubber boots that sit on top of the decking panel. Did rover use these on any other model of car? Mine have perished.
  4. Fuel Injector Rubber Boots?

    Range Rover Classic
    Hi All, I've looked all over for these... The rubber boots on my injectors are old and cracked. Does anybody know where you can get these? Thanks.
  5. Need new boots

    Range Rover Mark II / P38
    Hey all out there in RR world, need some help from P38 owners in the good old UK, Had a look under the front of my car ('97 P38 4.0) due to some light knocking going over speed bumps and found I need a drop link for the ARB, no problems. But I also noticed the dust boots on the steering track...
  6. Torn/Blown CV Boots - Any good DIY vids/write-ups out there?

    Range Rover Mark III / L322
    Gang, In the process of replacing my RF air spring assembly the other week I learned that I have one torn and one blown CV boots. Scanning RAVE I saw little on how to replace CV boots and good 'ol Storey Wilson has yet to produce a vid on this particular DIY. Let me know if there are any good...