Range Rovers Forum banner
blockage
1-4 of 4 Results
  1. Range Rover Mark II / P38
    Hello from Melbourne Australia My 2002 P38 seems to have developed a blockage in the EAS system. The bottom air inlet to the EAS dryer unit blew out; it's as if the outlet is blocked somewhere, causing so much pressure that the pipe fitting blew off. I took the dryer apart and all the white...
  2. Range Rover Mark II / P38
    Getting pending codes P0174, P0171, P0130 & P0154. (Lean trim and O2 Sensor). Also ever since I've had the car it has misfired / vibrated at full throttle and high RPM. Using torque I can see the O2 sensors working fine, but the other day I managed to catch it misbehaving. Flooring it up a...
  3. Range Rover Mark II / P38
    Hi Guys, Hopefully you can give me some help and guidance. Up until yesterday, my 1999 4.0 P38 was running very well.....apart from a small coolant leak that was coming from the thermostat housing. I ordered a replacement housing, and yesterday swapped it over. Drained from the bottom of the...
  4. Range Rover Mark II / P38
    I have noticed that I often have small pools of water under my car from the air-con drains but only ever on the drivers side. So I decided to investigate and check that they are both free and clear. I crawled underneath with a long screwdriver and located the ´flower bud´ drain points. When I...
1-4 of 4 Results
Top