binding

First technical post, and it could be a simple fix.... Anyways, i've noticed a bad binding noise coming from the driver side rear brake. I bought the Rover about a year ago, with 92xxx miles on it and had it serviced at a Jag/Land dealer for the rear brakes only as it was mentioned by the...

So here is my dilemma. I have a 2001 RR 4.6L SE, I just replaced the upper and lower ball joints. It only happens when I make right hand turns but the drivers side front tire seems to bind up. It feels like a coil spring is twisting and about to pop. It does slow the vehicle down quickly to a...

Got a bit of a head-scratcher on my hands! The other morning I was driving my Rangie and she cut out when the idle dropped too low (as she often does); no problem, stopped, put her into park and re-started the engine, but now I can't get her out of park. Figured out the brake light weren't...

After a few weeks of driving my '99 2.5 D P38 since the ABS and TC lights first showed (presumed faulty ABS sensor) the rear left disc got very hot on a 30 minute journey home on Tuesday. Fault Codes showing were: 84 - brake switch failure 1 - brake switch failure 75 - pump relay driver fault...

Guys looking for some feedback here. I'm new to this forum so apologies in the first instance if this has been previously discussed. I have a 2010 L322 that this week has developed what initially sounds like a binding from brakes. All front drivers side only but when going over a bump or speed...

H I Guys Just wondered if there is a common fault / problem with t RRS rear callipers ? my NSR appears to be sticking on (the disc is getting very hot) I have fitted new discs and pads and the piston went back easy enough using my spreader tool and I pumped I out a couple of times and it seemed...

I've been floating around the forum for a while but have finally run into an issue I can't find the answer to. I have a 95 classic LWB. A few weeks back I noticed a light bumping coming from the driveline which was related to speed. I paid it little mind at the time as I figured it was a u...

P38 4.6 Gems Engine binding (seizing) when warm - help please What would the engine to run fine when cold, but seize up, or sound like it, when hot. Took the car down to the garage for an MOT, it had run fine whilst bedding in the new cam, for 30 minutes in the garage It ran fine during the...

I'm new to this forum and hope someone can help. After several problem-free years of operation, the factory (Inalfa) sunroof in my 1991 Classic started binding and I discovered that a part of the rail mechanisms on both sides was broken. The binding occurred when the glass was trying to seal up...

Hi all great site hoping you guys could help me out ? the right rear caliper locks up on my 94 county SWB weird thing Is if I tap the brake pedal it releases I can hear the abs block Making weird noises every time it binds up I checked the book And it mentions rear end float so maybe bearings...

Hi there. I am new to your forum. I have a 2004 HSE. Passenger Rear caliper appeared to be locking up (Both sides were previously changed a year ago) and it was changed. Within a day the drivers side rear showed signs of grabbing. I check all the the hubs after driving each time (checking for a...