Range Rovers Forum banner
bent
1-10 of 10 Results
  1. Range Rover Sport / L320
    Long story short is I listened to a dealer when he said I’m clear of the defect of bad guides and tensioners on my car, 6 months ago car left me stranded 1000+ miles away from home when it threw crankshaft positioning sensor and started shaking violently. Got it shipped home and went straight to...
  2. Range Rover Sport / L320
    front passenger door was agar when reversing and it caught on kerb and bent to far forward now door is about 5-10mm forward as hinges are bent can they be straightened please . thanks in advance
  3. Range Rover Classic
    I have been having intermittent violent vibrations when driving and often thought it was bad alignment. That was done and it seemed to help a bit. Twice now I have been flagged down by another driver to be warned that my rear right tire is wobbling very badly. I have had it checked, the wheel is...
  4. Range Rover Mark II / P38
    Hi all, I'm going to have my wheels painted, but before that I want to have them checked for run out. My friendly mechanic seems a bit reluctant to do this (he would do it at the same time he fits new wheel bearings). Can this be done simply by eye, rotating the wheel on the car? Or is there...
  5. Range Rover Mark III / L322
    I bought a 2000 8HSE and in one week it was hit in an accident and taken to a body shop where it has sat for two months. The shop replaced entire cooling system and then told me The fuel pump went out and insurance refused to pay saying it was not related to accident. I paid and then shop says...
  6. Range Rover Mark II / P38
    I drove into a small mud pit (faster than I should have, but I was following other trucks who had no problem) on a trail and the front left wheel slammed into a hidden hole, and when I came out, the air was deflated from the wheel. Close inspection of the wheel shows an enormous bend in the...
  7. Range Rover Mark III / L322
    I am in the process of replacing timing chains, guides etc, overhauling vanos, sealing valley pan and replacing various bits and bobs whilst the engine is stripped down. All going well except! During removing the crank pulley bolt after heating and fighting and a lot of swearing, i had the crank...
  8. Range Rover Mark II / P38
    Ok so when I got my Rover last year, I noticed that the passenger side sway bar link was bent. I purschased the "All Makes" set with the two sway bars links and rubber for the Sway Bar, and installed everything. About a month ago I was putting new ball joints in the truck, and noticed that the...
  9. Range Rover Mark II / P38
    My car started to steer right, after putting on new winter tyres. I went to the shop and they rebalanced the tyres 3 times, no improvement. Then I went to another shop, they aligned the drag link, checked the tyre balance, nothing changed. My regular indy checked the steering box alignment...
  10. Range Rover Mark III / L322
    Camber angle problem with rear wheel - is upper wishbone bent? One of my rear tyres has worn badly on its outer edge I had my top hub bushes replaced not that long ago and I guess it’s possible that the camber angle was reset incorrectly at that time. However, when I jack up the vehicle to...
1-10 of 10 Results
Top