Range Rovers Forum banner
becm
1-16 of 167 Results
Advanced
  1. Range Rover Mark II / P38
    So today I decided to change the throttle body return hose because there was a crack in the rubber at the throttle body end. In order to dissconnect and remove it from the overflow tank I moved the fuse box out of the way. When doing this I briefly shorted BeCM contact #3 which is underneath the...
  2. Range Rover Mark II / P38
    After a series of key fob battery changes and re-syncs, Key Fob 2 no longer works properly. It will only re-sync as spare fob 3 so won't change seat position etc. When Fob 2 is re-sync'd Fob 3 won't work and vice versa. Any ideas how to get Fob 2 working again as Fob 2? :???:
  3. Range Rover Mark II / P38
    Hi All. Still havent resolved this no gauges or HVAC backlight issue. To recap, vehicle starts & runs good. HVAC works as it should. The HVAC display backlight wont come on.....up onthe dash I have no gauges working except SRS test light on start.. All gauges, info display & warning lights dead...
  4. Range Rover Mark II / P38
    The BECM in my truck was acting up, so I swapped the BECM, ECU and Instrument cluster from a different truck. The new BECM came without remotes and locks, so I don't have a matching remote. I have replaced the driver door actuator with a brand new part from LR before the winter, also the fuse...
  5. Range Rover Mark II / P38
    Hello all, It's ages since I've been on here. I've had my DSE off the road for about a year after it failed the Warrant of Fitness test (New Zealand) due to leaking manifold. I don't know which one, but I took one good look at all that piping and decided it would be too expensive to sort out...
  6. Range Rover Mark II / P38
    I have a BECM and M5.21 from the same car here, a 1999 NAS 4.6 Have unlocked the BECM, enabled EKA, disabled alarm, disabled immobiliser. Same security code in both Bosch M5.21 and BECM. Still comes up with the same. put his Engine ECU in another car, starts. but won't talk to his BECM. So I...
  7. Range Rover Mark II / P38
    Although I often follow this forum, it is the first time that I dare to participate to explain what is happening to me in my RR P38 2.5 TD LHD. The car worked with a key without remote control, one of the emergency ones, since it had the immobilizer canceled with the Nanocom. I had one of the...
  8. Range Rover Mark II / P38
    Does anybody know what the signal should be from C362 at the LH door outstation and the BECM when operating the key switch? Lines 1, 9 and 10 are my suspects Also, does anything change when 'alarmed' or so? I am still trying to sort out a lock mystery.
  9. Range Rover Mark II / P38
    (Sigh.. some must think I am going mad , maybe I am) On Saturday this italian diesel p38 ( my nightmare one coming back) threw a wobbler after the door latch didn't want to come up. Turned out staff had badly connected the stiff wire rod. Back in and it told me 'engine disabled (motor...
  10. Range Rover Mark II / P38
    Hello, while I discovered, what part ist NOT fitted in a SE Spec P38 I need help identifying the "crimps" in two connectors, as I want to use the plugs and patches, which are close to the full spec variants. The Connectors in question are C323 (12 possible wires) at the BECM and C305 (6 way)...
  11. Range Rover Mark II / P38
    Good Morning - I have a 98 Range Rover that needs a new BCEM
  12. Range Rover Mark II / P38
    My last gasp to fix my faulty temp gauge ('02 P38 Thor) is the serial link from the BECM to cluster but I can't seem to find the right plug/wires from the BECM on Rave. Any help would be appreciated. For what it's worth my temp gauge only registers bottom of the blue. I've checked/replaced the...
  13. Range Rover Mark II / P38
    Does anyone have experience replacing with a used part the BeCM? Also, does anyone have experience with the RSW solutions dongle and software, especially in unlocking the BeCM? Thanks
  14. Range Rover Mark II / P38
    I have recently purchased a 1996 4.6HSE (UK) car, which has spent the last 3 years sat in a field. It’s a CVC car (Land Rover owned) so is worth trying to rescue On arrival, the delivery driver connected the battery, turned the key to release the steering lock and shut the door – not...
  15. Range Rover Mark II / P38
    Hi, need help with problem I assumed was becm related, symptoms window switch pack , hvca , sat nav, radio wipers and cigar lighter all not working,becm has been back and forth between repairer who assures me its working, it was tried on three different vehicles.Sent fuse box back as well last...
  16. Range Rover Mark II / P38
    Trying to pinpoint the wire that goes from the BECM to the instrument cluster for the water temp gauge (2002 Bosch Motor). I've found the one that goes from the engine to BECM (green wire, pin 19, on 20way green connector). Any help appreciated.
1-16 of 167 Results
Top