RangeRovers.net Forum banner

attachment

  1. Bonnet earth strap attachment point

    Range Rover Mark II / P38
    I got interrupted from completing a head gasket replacement on my sons hand-me-down P38. The motor has been stripped down for 4 months, and now I can't remember where the bonnet ground strap attaches to. I believe it attaches to the rear lifting ring bolt on the head. This is the large strap...
  2. reusing window attachment clips?

    Range Rover Sport / L320
    Have a 2013 Range Rover Sport with broken R front door window. Can find replacement glass but cannot find new attachment clips (current ones are epoxied on). Any advice at reusing current clips. Thanks
  3. Door panels delaminating from attachment points... adhesive?

    Range Rover Mark III / L322
    3 of my 4 door panels have started to come loose from their attachment points. Enough being enough, I've started by pulling the rear door cards. The glue has completely broken down and no longer bonds the plastic attachment posts to the door card material. Does anyone have a suggestion on...
  4. Range Rover P38 XYZ transmission switch attachment

    Range Rover Mark II / P38
    Greetings, this is my first post here and I am normally a 'try and figure' individual when it comes to my Range Rover. However, I have an issue that should be easy to fix, but has just cost me dearly. The xyz transmission switch on my 1996 Range Rover P38 4.0 was acting up, refusing to shift...
  5. Gas Strut attachment to Glove Box liner

    Range Rover Mark II / P38
    Hello All, 2002 RR P38A 4.6 HSE LHD--Replaced Blend Motors, O-rings, Temp sensor. Has taken over a month to have time to do repair. Now have new OEM glove box strut to install but do not remember how to put it all back together. I get the brass-colored plate with the two bolts (RAVE, p. 953)...
  6. 2002 RR P38 running boards attachment hardware

    Range Rover Mark II / P38
    Hello, Have a 2002 RR P38 and just bought used running boards (side runners) that came with all the brackets, bolts and washers except for the inserts (collets?) that go into predrilled holes in the frame of the RR (need 8 of them). I have contacted BP of Utah, Atlantic-British, lrparts, local...
  7. Seatbelt attachment / wheel arch rust failure?

    Range Rover Classic
    Hi there. I'm looking at a 1991 RRC. The engine seems strong, but it's a rusty mess. The worst I saw was on the rear seat seatbelt anchor point, which was basically being held in place by the carpeting. The photo is looking up from the wheel well, directly through and into the cabin. Is there...
  8. Snapped attachment to window pane?

    Range Rover Sport / L320
    Somehow the sliding plastic attachment between the rear left door window regulator assembly and the glass pane itself snapped. The window dropped to the bottom of the door panel and the regulator attachment/slide was free to move up and down. I pulled the trim panel and the speaker and reset...
Top